Search results for query: *

I'm also very interested in this. We've had this issue now for several months since ATT turned up 3g in my area. Just like Jfaraone, if I turn off 3g on my phone and use Edge the caller id works great.

I applied the route-map the the lan interface and it's working, thanks! Travis

No, I haven't applied the route-map to the LAN interface (FastEthernet 0/0). Are you suggesting I do that or just inquiring? Thanks. Travis

I've tried using an acl as follows: access-list 101 permit tcp any any eq www I've tried several items with the route-maps including the following: route-map http permit 10 match ip address 101 set ip next-hop xxx.xxx.xxx.xxx (cable modem default gateway) also tried set interface...

We've got a site that has a T1 to our MPLS network and their web traffic travels across the MPLS to the datacenter and then out to the Internet. Rather than pay for more bandwidth on their circuit, they have purchased cable Internet through their local provider. I have configured FastEthernet...

Card is in correctly, or was in correctly I should say.

Card is definitely in, I'm about to pull it out and make sure it's right side up.

I've tried hitting escape while powering it up on different computers many times and I still just get the same screen I posted earlier. I guess I'm just going to send it in for repair.

It transferred the image and failed while performing the upgrade. I've used the same file for upgrading two other IP 500 units. I rebooted it after it failed and this is what I'm stuck with.

This is what I see in HyperTerminal when I connect with a serial cable. However, I am not able to enter any commands at the blinking cursor. <--Start of HyperTerminal Sesssion--> CPU Board Version is: 0xC0 CPU PLD Version is: 0x17 CPUID: 0x02 Present: 0x0E Present2: 0x02 Using FPGA build...

I've tried the reset button several times and it does nothing at all. I've tried holding it anywhere from 5-60 seconds in various lengths and nothing ever happens. It doesn't even reboot after I try and reset. How do I go about the "DTE" process? Thanks!

I have a new IP Office 500 unit and I performed a software upgrade that failed. Now I am not able to connect to the unit through the Manager software. When I power the unit on, I get all solid red lights on the front, a solid green C/F light on the back and no CPU light. Any ideas?