Search results for query: *

this works on a 2900 switch so don't know if it works on this one. make sure you are on console port hold the "mode" button on the front of the switch at the same time you turn it on, let go of the mode buton a sec or 2 after the led light above prt one is no longer lit. when...

I'm not sure on the catalyst but i think it might only run isl on the link, if it does then the netgear and cat won't talk. check to see if the cat can use dot1q to talk if so change it on the encap of the link. good luck not to sure on the netgear stuff.

start at this possiblity i know it works on 2950s switch#vlan database switch(vlan)# vtp domain (Name) vtp mode client|server note this is not in config mode, not sure on these 19's but should set it up on all sitches one is server others client to get info from server switch, all need ip on...

3550 should take a WS-G5484= for multi mode short haul for long haul 5486 on 2950 48 should be the same check this link for info http://www.cisco.com/univercd/cc/td/doc/product/lan/cat2950/1219ea1/ol236202.htm good luck

if you want 3 vlans you should make them 2-3-4 because 1 is the default on all ports and is used for management of switch.you have rsm or external router? sunets on each vlan, make switch server so you can modify vlans in client you cant modify them.good luck

you have to make sure that you have the speed and duplex set to 100 and full on both ends.it has to be 100mb or you can't trunk.make sure you do it on the interface you want to trunk. use show controller to see what encap you can use.you need same encap on each end.

you need to write the acl so that the establish command is used on the interface after the other two commands or it may not work right sometimes. the data is not an established connection. it never had the established bit turned on from the source. which in this case is the server that the ftp...

switch will work fine with this only ? why two routers at home? it is good idea for security to have double, but nat on the pix should do fine for the switch and security. is pix cisco? look at cisco.com for info on the pix and nat. luck

try this link for your answer, it should help you through it all.luck. http://www.cisco.com/warp/public/556/12.html

if you have an extra computer around you could use it as a host for the modem and then run it through a switch, from the switch to the router ehter interface then back to the switch,alot of configuration for this router to work. you need to sub-interface the ethernet on the router and make the...

did you put in the ppp auth chap command ? it needs to go on the interface you are using to send ppp.

if you are setting up v-lans and the servers are to be used by all v-lans they have to go through the router no matter what ,to get to the servers from the different v-lans wether you put them together or not. you will need to use ISL for the router to route the vlans.look at cisco web site for...