Search results for query: *

Thank you very much Mitch. That was quick, easy, and painless. Have a great Holiday!

Hello everyone, I have a postage meter connected to an analog 793B card on a Definity SI release 6. This meter used to be on a pots line and worked without issue. The customer has recently switched to a PRI so I added an extension on the analog card for this device and was hoping someone could...

Thanks for eveyones input. I have solved the issue. I needed to add a data module set up as a proc interface. I also had to enable comm link. cmo101101

I have swapped out each component and I can get either circuit working in slot 12 but not slot 10. When I do a status of signal group 2 It shows manual out of service. Is it possible that I need to add a data module and a processor channel? In slot 12 which I have assigned to sig group 1,I do...

Hi All, I have a definity csi release 6. I have an exsisting PRI circuit installed that is working properly. I have recently added a new PRI circuit. I am using a TN 767E module and I am using a 120A CSU. I have added the trunks to the same trunk group that the first T1 is assigned to. The...

Thanks tdaugirdas, Does that mean I need a contact closure adjunct? Will the adjunct that is designed for Partner work? I dont see anything in the documentation on contact closure adjuncts. Do I just connect the adjunct to the analog port and assign that port an extension and have someone dial...

Hi everyone, I have a Merlin Magix release 4.0 and I want to be able to press a button on my phone to release a lock to open a door at my establishment. I have a: Processor CKE5 412 TDL 024 TDL 016 T/R Merlin Messaging Do I have the right equipment to make this happen and if so where do I begin...

Thank you tdaugirdas, I kinda figured that was the issue. cmo

HI all, I have a Merlin Magix system r4.0 with (2) 412TDLs (1) Merlin Messaging I have the Auto attendant anserwing the calls immediately and when the client dials selector code 5 the call goes to Group 771 which has ext's 110,111,112,113,and 114. The calling group is set as ring all and set...

Thank you all that was the problem. cmo101101

I have already assigned the voicemail extensions to have remote call forwarding and also trk to trk transfer. I will try changing them to unrestricted and also raise the FRLs. I will let ya know how it turns out. Thanks tommy. cmo101101

I have verified that the extension is in call group 30. I tried going to the voicemail parameter for mailbox 171 and programmed it as not having a phone for that extension and now the call goes directly to the voicemailbox for extension 171. So that verifies that the auto attendant is trnsfering...

I have a Merlin Magix Release 4 Equipped with: slot 0 ---CKE Processor R 4 slot 1 ---412 TDL slot 2 ---412 TDL slot 3 ---Merlin messaging I have an extension (171) with a call forward button. when I place the extension in forward I dial 9 then the number followed by #. I get a green LED showing...