I do my own maintenance but I have a slight advantage. I am retired from AT&T/Lucent/Avaya and my job was installing these systems while I worked for them so I do have an intimate knowledge of them. After retiring I worked for a BP for three more years, then I left there and now work for one...
As far as I know, the ARS table cannot be increased. But I must admit I have never seen anyone fill it, it is a huge table.
Perhaps it would be easier to deny everything and just put in the numbers that can be called :)
Most of the time I see this issue it is because the CO protocol does not match what you set on the DS1 page.
Do a "test board (DS1 board location) long", cancel the test after test 146 because you are not interested the remaining tests. Do any fail?
Of course I need to ask the silly question...
Why would you want to do this? The system is running maintenance at that time on all its' processes including backing up the translations, comparing the backup to the live set to make sure all is well, testing all the cards and doing everything short of a reset.
You would need to change the...
One thing to keep in mind on this is when you buy a used Avaya PBX, all you are buying is the hardware. The software is not transferable, it does not matter what release it is. Sure you could buy one and not tell anyone, assuming that you got a usable login. But if you ever needed support from...
There are many ways to do this, and you will probably hear all of them. I will give you one, if AAR is turned on in the V3 then make 6 an AAR code. Change the DAC for the trunk group from 6 to some other number. On the AAR table have 6 route to a new route pattern that only allows a dial string...
Since I have multiples of both certs I will throw in a comment here. You only need to take each core test once, after that all you need to take is the elective to get another cert.
As the first ACS cert I would suggest IP Telephony because that is a good general purpose cert and will make it...
Been reading this thread with interest but I read a comment that is partially incorrect. A TN750C will work in CM3 if the announcement is already recorded on it when you upgrade to CM3.
You cannot add announcements, change announcements, save announcements, or restore announcements to a TN750C...
I know this is an old thread but I just joined and was looking through old posts.
With a single mode fiber transceiver you always have to use attenuators. The old documentation said to put them on the receive fiber at both ends and you want the attenuator that will get you down to -17dB which...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.