Q-SIG problem

[themegalord]

Is there a way I can configure a Prologix system (ver 11.2) to run with voice mail (over ISDN BRI) without Q-SIG license installed. After configuration, the remote PBX (with voice mail) sees the trunks as down i.e. out-of-service, but the D-channel is up. However, if I convert the service to raw-bits, everything seems to work just fine, but without the VAS i.e. caller-id, call-waiting etc.?

 

[98Converter]

Have you tried DCS between sites?

Your Intuity may need DCS turned on for this.

Thanks,
CJH

We are what we repeatedly do. Excellence, then, is not an act but a habit. ARISTOTLE 384-322 B.C.

 

[themegalord]

98Converter,

No way man, We dont have DCS turned on. But we actually use ISDN over packet.

Thanks.

 

[llkrj58]

Most of the time I see this issue it is because the CO protocol does not match what you set on the DS1 page.

Do a "test board (DS1 board location) long", cancel the test after test 146 because you are not interested the remaining tests. Do any fail?

Of course I need to ask the silly question also. You do have ISDN PRI enabled in the customer options of both switches?