No, I justed removed the ports from the trunk group, signaling group, and ds1 then removed the card. Then popped in the new card and it showed up in li config all right away. Then I created the ds1, signal group, trunk group.
I'm trying to remove a TN464F and add a TN767E. Prior to removing the card I removed the card from the trunk group, deleted the signaling group and deleted the ds1. Then I installed the TN767E, created the ds1, created the signaling group. But, when I checked the status of the signaling group...
I'm trying to remove a TN464F and add a TN767E. Prior to removing the card I removed the card from the trunk group, deleted the signaling group and deleted the ds1. Then I installed the TN767E, created the ds1, created the signaling group. But, when I checked the status of the signaling group...
Last night I tried removing a TN464F and adding a TN767E. Prior to removing the card I removed the card from the trunk group, deleted the signaling group and deleted the ds1. Then I installed the TN767E, created the ds1, created the signaling group. But, when I checked the status of the...
Last night I tried removing a TN464F and adding a TN767E. Prior to removing the card I removed the card from the trunk group, deleted the signaling group and deleted the ds1. Then I installed the TN767E, created the ds1, created the signaling group. But, when I checked the status of the...
Last night I tried removing a TN464F and adding a TN767E. Prior to removing the card I removed the card from the trunk group, deleted the signaling group and deleted the ds1. Then I installed the TN767E, created the ds1, created the signaling group. But, when I checked the status of the...
I swapped out a TN464F for a TN767E but it looks like the d-channel will not come up. I getting a out of service notice when I status the signal group.
Yes, it does? What exactly is ISDN over PACCON.
I have a location on version 6 that does not have it and they have TN767e's.
Avaya was trying to tell me that TN767's are not supported on version 6.
Thanks.
When I try to change communications-interface links I get the error message: 'ISDN-PRI is not supported over PI links'
G3si version 6
I have 5 TN464 installed fine and I'm trying install TN767. I also have a TN765 card.
Please advise.
I'm trying to setup an auto attendant in merlin messaging that when someone hits that auto attendant they get a greeting to enter the users extension. Then the user enters the extension the user is transferred directly to to the users mailbox, without ringing their phone.
Please help.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.