Search results for query: *

Which was.....?

Depends on the page count...if you're getting close to 200K get the kit. If you're below 100K, your feed/sep rollers should be in good shape. Not that difficult a job.

Need to replace the fuser assembly.

Try the HP 4 driver.

I really doubt that it's any of those areas causing the problem, otherwise why wouldn't it happen on any sized print job. If your printers are getting up there in page count, I'd be replacing pickup and feed rollers and separation pads in the trays. I'd bet you're getting a timing issue...minute...

Totally different printers and different cartridges. The 95A is twice the size of the 75A!

You shouldn't be getting wrinkling with the gray envelope levers in the up position. If you are, the envelopes are not laser quality or they are of poor quality. (or it could just be very humid conditions) Check your manual or the HP website for envelope types recommended for the printer.

Go to kahlon.com for reasonably priced memory.

First thing to do is eliminate the toner cartridge as the problem...try a different one...even and empty, just to see if noise goes away.

Press both buttons together, momentarily to print a configuration page...does it show a duplexer in the options?

It should if the pdf is more than just text. Are you using the latest PCL driver?

You could try reloading the latest driver from the HP site, check your printer cable (reseat &/or try a different one).

You will get this error when the LC has been selected and the PC (tray 2) is not installed, or not installed properly. You need tray 2, as it is the paper guide for the LC. Check out tray 2 for a problem,(reseat) as well as the contacts that sense that it's installed.

Review this info: http://h20000.www2.hp.com/bizsupport/TechSupport/Document.jsp?objectID=bpl11038 You can also try downloading the Win2000 driver.

...I'm getting confused here now; your subject heading was for a straight HP 2100...now you say it's a 2200TN, though the TN is self explanatory, seeing how you referred to tray 3 and server connection. But if it is 2200, Cold Reset is powering on with Go button only pressed, until the Attention...

If tray 1 is empty and your application is set for one of the lower trays or 'default'and you get the attention light on, will it print from another tray when you press the Go button. And is only the attention light on, or is the small LED by the large Go button also on? You could be...

hpwizzard (Ahem...cough, cough)...unless there is a misprint in the Service Manual, it's the JOB CANCEL button. It's always worked for me....[peace]

Your printer has more than likely been set to Manual Feed = On. To remedy this, you should perform a cold reset on it. Power down the printer, then press the Job Cancel (small) button down while turning the power back on. Hold the button until a the LED’s are lit. If you are using a JetDirect...

Don't forget, there are 15 work stations...I don't think the 1300 is a viable printer for that kind of use.

Go to www.printerworks.com for diagrams.