Search results for query: *

If calls can go with RSC 8 ARRC is good, Check ARSC for the outgoing route that RSC 7 is a 1 for RRI 2 and 3 if it is not a 1 but is set to 2 then there is toll denial and you can check ATDP or ADNPRL, it would be easier to change it to a 1 if needed. Checked which service feature class the...

If they are DIT'd In ASCI it will prevent you from deleting them.

Haven't worked on a UM8000 for quite sometime and do not recall, in the 9300 you can set 08>140 to 0 to light up a line appearance that has new voicemail, then add a line appearance of the extension on the phone set up a speed dial to dial the voicemail pilot number enter the mailbox number etc...

We used a product called VS Logger from Versadial. https://www.versadial.com/

You will get this message if trying to use an ACD line that is already assigned. List up position data and compare with the extensions they are trying to assign.

In ARTD for your incoming route CDN 50 = 1 , CDN 98 = 1, CDN 112 = 0 for your IP CCIS route on both sides CDN 50 = 1 CDN 98 = 1 and CDN 112 = 1 is how this should be set up. In the MG-SIP cdn_pattern and cpn_pattern are usually set to Userinfo and set name_display to enable. TIE is the name of...

You might want to see if the number is call forwarded to an invalid number, if not you may want to check command 200, i.e. 200>2>804 this makes 2 valid for 4 digit extensions.

Does your carrier allow you to send different caller ID? ACPNCL is the correct command.

The only other thing I can think of is in the admin menu of the phone you can specify what EHS cable you are using the default is none but there are options for APN or APD type cable, I have never had to change this from the default but you might want to try that.

Is this an 8 button with the two displays? Try a different phone a 12 or 24 button, also it is possible that the pins got bent on the phone when plugging in the cable, had that happen before.

Also - if you plugged everything in with the phone powered you will have this issue and will need to unplug the phone and plug it back in.

Just leave it at 0, and the programming I entered is the correct way to set up the phone for a headset and EHS cable

Are you using DHCP? If so set up option 120 with your IP Address then the phone will come up to the login screen. There was a way to have the phone retrieve a config file by using DHCP option 153(I think) that would tell the phone to get a config from a server never did this though. If you log...

In ADKS LKP needs to be a 3 and then in AKYD make TP = 1 and then program the headset key on button 25. You may want to unplug the phone and plug it back in as well.

You will want to set up a Wireshark trace.

Can you try using one of the existing routes and assign trunk two instead of using a new route and have the access code select trunk two. This would eliminate a route data issue. In ARTD RLP CDN 8 should probably be set to 2 as well.

We used a product from Versadial, had good experience with support staff and price was not that bad.

Check 84-13 and 10-02-02

There quite a few steps to set this up for the initial setup too many to post here. You really should consider getting you vendor involved.

LMAC will list up MAC's with extensions.