Recent content by voicetec1

OK Trason806....I'll keep kicking around and see what I can turn up. Thanks for your input.

Here's the tn TN 012 0 09 13 TYPE 3904 CDEN 8D CTYP XDLC CUST 0 ERL 0 FDN 24020 TGAR 10 LDN NO NCOS 4 SGRP 0 RNPG 17 SCI 0 SSU LNRS 16 XLST CLS CTD FBD WTA LPR PUA MTD FND HTA TDD HFA GRLD CRPD STSD MWA LMPX RMMD SMWD AAD IMD XHD IRD NID OLD VCE DRG1 POD DSX VMD SLKD CCSD SWD...

Can't use XMWK as the PDN is VMB. All agents have a unique dn on their sets and that dn is listed in the MWI for the VMB. Added another scn to a set and made that a dn in the VMB and added a key xmwk 6000 28108 and that didn't work.

All Agents need MWI. Trason.....I'll give it a try and repost

Agents need to have a MWI on their M3904 when a voice mail is left in the Queue's VMB. Any help will be great.

The staff can call the other cs1000 with LOC code and dn. They calling from 3904 sets on a cs1000. The point is the switch is doing exactly as it should. You can't make an outbound call from the switch and then transfer the call off it. I have been able to setup a 500 set with ftr fdn 22600xxxxx...

I have nursing staff that make calls to patients and if the patient needs to be seen again they need to transfer the call to a scheduling call center that resides on another switch. The sites are linked by PRI and SIP trunks. I am told that it is for security reasons that you can't do. I don't...

OK I will go to MerMail and kick that around a bit. Thanks for the MIK/MCK lead. Never would have tried it.

Ok I pressed the MIK key and entered 25156 and presed the MIK key and the lamp cqame on. I pressed the MCK key and entered 25156 and pressed the mck key again and the lamp turned off. So I guess the lamp works.

Ok I will give it a try.

Only one set.

I have the Key 3 value.

OK The SDN for Voice Mail is 6000

Not working. What is suppose to be displayed if it is workinh?

OK thanks for the help. I will give it a try.