Recent content by RickChaisse

I have a Satellite dish with 3 LMB's. The first two work fine. The 3rd one doesn't seem to work. Is there a trick to this ? Or is it defective ?

Hi All, Can anyone give me some info on setting up toll restriction on a Toshiba DK-16 and allowing the customer to put in a code to bypass it ? Thanks, Rick

Well, I finally solved MY problem.. I was using a Viking Phone-line simulator to call into the system. ( this was a pre-installation project ) As soon as I provided CO dial-tone, it stopped dropping the transfer. That probably doesn't help you, Teledial, but maybe someone else reading this...

Ok, I just made another test.. it's definitely NOT the VM unit.. I call in to the Phone system, I answer the call and transfer it. If I transfer the call to the extension that is not forwarded outside, the transfer is normal. If I transfer to the same extension, but now it's forwarded to...

This is looking more and more like it's something with the VM.. I set the COS to Supervised. I programmed the phone to dial the time and I monitored the CO trunk that it was to call out on. Everything went fine right up until the Time-Lady answered the call.. the call immediatly dropped and...

I'm having the same problem. ( what a coincidence ) One thing you want to check is dialing the extension from another extension. If it goes through ( like mine does ) then I'm assuming it must be something in the voice-mail. I've changed class of service for the mailbox to '8' but still no...

ok, I get the message. Thanks, you all.

LOL I was hoping there would be a programming parameter that only the X telco guys know, that isn't in the manual.

Does anyone know a way to change the speed interval of the speed-dial digits. The customer lost programming and we notice that the interval is extremely fast now and won't trigger a gate on the property. I've looked through the manual and can't find any reference to this. Thanks, Rick

Thanks for the info, Merlinman. I'll set up the SMDR to see what's going on. I'm wondering, rather than add another T-1, can I have a few more standard outgoing trunks that could handle an overflow from the outbound PRI ? Or am I getting too out there ? haha ( they're complaining about...

I have a legend 7.0 with PRI. I belive that due to many realtors having their extensions forwarded to their cell phones, we're getting complaints of incoming callers getting busy signals. Is there any way to track this ? Is another PRI possible ? Is there a better cost effective solution ? Thanks.

I figured it out.. NtwkServ requires an entry for every table.. Since it isn't highlighted, even in table '0', I figured it was the default for all. Wrong again. Thanks to Jinx & Merlinman for responding so quickly.

Here's the test I did.. A Entry Number: 0 1 2 3 A NtwkServ: Any Service A Expected Digits: 3 3 0 A Pattern to Match: 113 114 A Digits to Delete: 3...

I have a Legend 7.0 with a PRI. I have been unable to get any table in the Dial Plan Routing to work except table '0'. I swapped out the Processor with the same results. Am I missing something ?