Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

only 1 dial routing table working on PRI

Status
Not open for further replies.

RickChaisse

Programmer
Sep 5, 2005
38
US
I have a Legend 7.0 with a PRI.
I have been unable to get any table in the Dial Plan Routing to work except table '0'.
I swapped out the Processor with the same results.

Am I missing something ?
 
I would say we would need to see a print of the PRI to see how the tables are translated.
 
We will also need to know digits being sent and what you are trying to route them to.
 
Here's the test I did..

A Entry Number: 0 1 2 3
A NtwkServ: Any Service

A Expected Digits: 3 3 0

A Pattern to Match: 113 114

A Digits to Delete: 3 3 0

A Digits to Add: 313 314


The first table will work no matter what I put in it.
The second, third, etc will never work.

Is it possibly the 'Any Service' status, rather than a specific NtwkServ ?



 
I figured it out..

NtwkServ requires an entry for every table..

Since it isn't highlighted, even in table '0', I figured it was the default for all.

Wrong again.

Thanks to Jinx & Merlinman for responding so quickly.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top