Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by PhoneFixer98

  1. PhoneFixer98

    Outbound Line selection.

    Yeah yeah, I just realized what I said too.. :) Thanks for the correction.
  2. PhoneFixer98

    Outbound Line selection.

    Add ARS 51 as the Backup Route- Put it in ARS 50 as Out of Service Route.
  3. PhoneFixer98

    History dialing

    Most CID I see has 10 digits as well. I find the call in call logs, press my trunk access code (9), dial 1, then push the button next to the number in the call log.
  4. PhoneFixer98

    0 out of auto ATT.

    Putting the 0 in would be only for a test. The transfer action should let you transfer the call almost anywhere you want. It sounds like there is a conflict somewhere with 111. Temporary work-around, until you find the real issue, make another shortcode for the second AA.
  5. PhoneFixer98

    9508 Phone on IPO R8

    The freezing issue has been fixed in 8.0.43 (I have several of them out there, and have not been locking up since the upgrade from earlier 8.0's- just make sure the sets get the new firmware from Manager after the upgrade) 8.0.44 is the newest R8, and that fixes the gain settings on ATM Trunks...
  6. PhoneFixer98

    0 out of auto ATT.

    Try putting 0 in the specific tab of the Transfer action..??
  7. PhoneFixer98

    Call coverage to a calling group

    How about looping an unused ext port to an unused line port. Set the looped ext in the selector code transfer. Then make phones ring immediate/delayed/no ring accordingly...?? Might work...
  8. PhoneFixer98

    Call coverage to a calling group

    Not too sure with out trying on a system, but I am under the impression that you should be able to set a selector code to ring calling group 1 by assigning it to ext 71.
  9. PhoneFixer98

    Toll restriction questions

    You will want to have the entries just as you had them above, 1800, 1877, etc... Make sure to use the "Enter" button after each list entry and assign the list #408.
  10. PhoneFixer98

    Toll restriction questions

    *Correction- #406, not #409...
  11. PhoneFixer98

    Toll restriction questions

    #401- 3- Local Calls only, rejects a call if 1 is the first dialed digit. #409 overrides #407, which both override #401.
  12. PhoneFixer98

    Remote Audix Voice Mail

    I heard that the Remote Audix VM should be returned to IP Office R 8.1..?? I hope the source of this rumor is correct. If not, I bet enough squeaky wheels could get it done by R 9.
  13. PhoneFixer98

    IPO R7.0.31 with Remote Audix

    Voice mail type is Remote Audix- destination is your Q-sig/IP line number. Audix UDP # is the VM access hunt group for the CM/Definity. Short Code for VM Collect (?U) needs to be same line group as the Q-sig/IP line. Is all you need in IP Office. Further configuration on CM/Definity should...
  14. PhoneFixer98

    Call Restrictions with Line Appearances

    How about user short codes for each restricted user: N Barred Blocked (to keep from outbound on Lines) 9N Barred Blocked (To keep from outbound on CA) 911 Dial 911 (to allow 911 on Lines)

Part and Inventory Search

Back
Top