Recent content by nfcphoneman

In PGM 132, try changing "Use Board IP for SIP" to "On" I believe the Sequence number for the eMG80 is usually 13. You can double-check in PGM 101. www.jacksonvilletelephone.com Jacksonville Florida Telephone Systems

You say "crappy", I say "convenient". www.jacksonvilletelephone.com Jacksonville Florida Telephone Systems

Perhaps the best thing to do would be to turn off the hold-recall reminder by setting the timer to "0". www.jacksonvilletelephone.com Jacksonville Florida Telephone Systems

In PGM 160, try turning off TLS. You may have to change the web server to port 80 in PGM 161. www.jacksonvilletelephone.com Jacksonville Florida Telephone Systems

Annother question a last: for activating Phontage/UCS, can i write in any type of key in the value field under System lock key install?" No, that's for the lock key from the manufacturer. I don't believe E-LG is supporting the MFIM any longer. www.jacksonvilletelephone.com Jacksonville Florida...

Digital phones connect directly to the control unit via traditional phone wiring. IP phones use Category cabling and IP networking. You can use VoIP, in the form of SIP Trunking, with digital and analog phones with the emg80. www.jacksonvilletelephone.com Jacksonville Florida Telephone Systems

Was hoping you was going to tell me of a way of restoring an MFIM backup to a UCP to save a day or so's programming." I believe you can do this with OWA. I only had to do it once, but I remember doing it and it actually worked! www.jacksonvilletelephone.com Jacksonville Florida Telephone Systems

Yes, on the MFIM you'll need a VOIM24 and we'll need to spend some time setting up the proper port forwarding on your router. The UCP can expand to 20 VoIP channels with just licensing. www.jacksonvilletelephone.com Jacksonville Florida Telephone Systems

I believe your issues will go away if you switch to "Remote" for the phones. However, each internal call when then take up a VoIP Channel. www.jacksonvilletelephone.com Jacksonville Florida Telephone Systems

I "think" it is under "System Attributes", "Attribute II", "No DSS Indication". www.jacksonvilletelephone.com Jacksonville Florida Telephone Systems

Under SIP CO Attributes, look at the settings under "Offnet Call Route ID Transit". Need to change some of the settings to "Original CLI". Not sure which one you need to change, but I have From/Contact ID, From Display, P-Assertid-ID, and Remote-Party-ID set to "Original CLI"...

Yes. www.jacksonvilletelephone.com Jacksonville Florida Telephone Systems

Don't forget that the IPECS has a built-in Access Control List. You can whitelist the IP's (or ports) you need to have access to the system and deny the rest of the world. www.jacksonvilletelephone.com Jacksonville Florida Telephone Systems

Yes, you're right. Sorry, didn't take the time to look to see if it would work with analog extensions. The only way I can think of doing it would be to make a station (ring) group for each extension that contains the VoIP phone and the analog extension. You would then call the group number and...

Wouldn't Call Coverage work? www.jacksonvilletelephone.com Jacksonville Florida Telephone Systems