Hi Guys
system 3300icp MXeIII
software MCD 4.2
Problem: I programmed some analog extensions and I am not getting dial tone.
I also tried an ip set but there is no dial tone.
Hi all,
I just upgraded a CXi controller from 8.0 to 9.0
I did a backup 2 days before.
I started by connecting to 2 port on a phone and started upgrade.
The system did a backup and then I lost connection to controller.
I then connected to WAN port and upgrade did not move.
I then stopped...
I am installing software on a new system and the below is what I get. Software MCD 4.2
boot device : qefcc
unit number : 0
processor number : 0
host name : bootHost
file name : Boot_Install
inet on ethernet (e) : 192.168.1.2:ffffff00
host inet (h)...
I was trying to activate the serviceLink but gets this message.
The following error(s) occurred during activation:
Invalid signature for service account ID '29573364'.
Hi Nupoint Installers. I am trying to install NPUM on customers server and I get the the following results below. Any idea why I will get these messages.
The NPMFinalize-14.2.2.15 blade was successfully installed.
WARNING: the sync with the AMC during the blades post-install event failed with...
Hi All,
I am installing nupoint messenger.
I tried to assign lisence for NuPoint Unified Messenger: Standard UM - 50 Users but I get message of base component missing.
This is what is available
54005195 SWA MCD BASE (INCL 16 USERS) 2
54000294 3300 ICP: 1 Device License...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.