Recent content by KZ9Y

np247, I don't remember what exactly I did for someone some years ago. But I think there is a ring timer that can be set. Maybe this will jog someone's memory. >****

KCFLHRC, I knew it was a long shot. But I just couldn't believe that I had ten in a row with bad displays! Wonder if a hair dryer would do any good? >****

Mobus, A very timely post - for me at least. I had our vendor on site yesterday (and is returning soon) and one of the reasons was to see if corruption in the switch could be causing the failures. Ten in a row! Right now I have a set sitting on the switch terminal as it's running a bit higher...

Inadvertently launching second instance of Procomm will create that error on my Win7. >****

You log in to this forum every day! >****

Hi all, Requested an Analog Line Card just to have in case one of them blows up. Asked for NT8D09CA and recieved NT7K20ABE6 RLSE 01 from Avaya. Card is also marked GALC and has a serial Maint port on the front. Is this thing going to work for our Type 500 sets? Thanks, >****

All, Never mind. Found my own answer in Octel's Vol. 3, Chapter 8, Pg. 63. Establishing Extention Mailboxes. Thnx, >****

All, Sys. is CS1k w/ Octel Aria hanging off of it. Have a S/L 500 set that is shared between two users. Can I put two vmail boxes on the extention? Thanks, >****

MA, You changed your tag line. Now that is funny! >****

Something like this happend to me about a year ago. If I remember correctly - a reset on the MIRAN card cleared the trouble. >****

The attached may help. Also in the attachment is a trouble shooting flow chart. >****http://www.sandman.com/rfbull.html

Not sure if this info. applies to your situation but good info. anyway as you may eventually run into this situation. The following is how we transfer calls to Octel vmail. Press Transfer, dial 4499, pause to hear one ring, press **, listen to prompt for mailbox number, dial mailbox number...

Hopper, Check out Section 6.30 in the DX-80 manual. It's a timer instead of number of rings. >****

Solution: Chanel 7 was disabled. That was the main culprit.(I didn't catch that as chanels 0 - 3 were IDLE). Chanel 7 was ENLU'ed and went idle but I still was not able to modify recordings. MIRAN card was DISC'ed then removed from backplane and put back in. Card was ENLC'ed. All is well with...

I think we're going to wave the white flag on this one and let our vendor deal with it. Will post the outcome. Thanks all. >****