Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by jmcevoy

  1. jmcevoy

    NBX logs

    Hi All . Can anybody advise where the logs are stored on an NBX V3000 , I have a system that seems to continually loss the available memory , As the log files are quite large i would like to clear them but i am not sure how . Any advise you can offer on the log or memory would be appreciated...
  2. jmcevoy

    NBX calls auto cut off after 4 hours .

    Hi . does anyone know of any settings on the NBX that would cause calls to disconnect after 4 hours . I have been asked about this today and i can't see any info , Only thing i can find is a line provider fail safe disconnect . Any info will be appreciated . Regards . John .
  3. jmcevoy

    NBX MoH

    Hi . Can I please ask if any of you know a way to get the NBX to play beep or any tone for calls placed on hold , When there is no External source connected ? I have tried today and can only hear silence when on hold , This is the same if MoH and MoT under system wide is ticked or unticked ...
  4. jmcevoy

    Vlan tagging on 3102 phones .

    Thanks for the info .
  5. jmcevoy

    Vlan tagging on 3102 phones .

    Hi Guys . Can I please ask if any of you have experience with setting Vlan atgging on these phones , What i need to konw really is can the data port be set to a different Vlan as the phone port . I know i can set the Vlan settings on the phone using the program key . Just not sure if i can...
  6. jmcevoy

    Night service

    Thanks Steve .
  7. jmcevoy

    Night service

    Hi . I am looking for the programming code that is used to set the time for the night service to kick in automatically at say 5:30pm . I have just forgotten what one it is . Regards . John .
  8. jmcevoy

    Panasonic KX-TDA30 BRI problems .

    BT have finally admitted Fault at the exchange . Thanks for the Help . Warm regards . John . This can be Closed off I can't see how to do it .
  9. jmcevoy

    Panasonic KX-TDA30 BRI problems .

    Hi Thanks for your reply . I have checked the settings and they match your suggestion . I have also uploaded a copy of the config witch can be viewed with the unified maintenance console . I have swapped the ports on the system and the lines dropped off in 3&4 instead of 1&2 so it does seem...
  10. jmcevoy

    Panasonic KX-TDA30 BRI problems .

    Hi ALl . I have A Pana. KX-TDA 30 that is having issues with BRI . Here is what i have experienced so far . Lines 1&2 drop out intermittently leaving only 2 line out of 4 working . System is set point to point . BT Tell me the lines are set point to point . I have Changed out the BRI 2 card...
  11. jmcevoy

    vacant number message when ringing busy attendant LDK-300 Hotel

    Turns out they had an Analogue phone plugged into a Digital extn. port and the attendant problem was incorrectly reported . Thank you all for your help .
  12. jmcevoy

    IP LDK20 - simple analog 4 way setup

    You would first need to check if you have a BRI or LCOB system , If it has a BRI card you can't connect one analogue line to it without the LCOB .
  13. jmcevoy

    Aria 24IP

    Is the SLT connected using an adapter ? If so Please try a PABX master adapter or check the SLT for a ringer volume switch or slider .
  14. jmcevoy

    IPLDK 60 not start "SCOUT-DX V1.1 NO SYNC" DISPLAY

    Hi is the PABX Adapter your phones connect into a slave or master ? If master you need slaves and your Digital key set will not work with the capacitor in the Master adapter . If connected to Sockets and not a cat 5 network , Open the socket and check for the (Usually Yellow) capacitor and...
  15. jmcevoy

    ip LDK 100 flexible button codes

    Hi Mallers Do you have a copy of LDK PC Admin software ? if so it is easier to change the programming on Flex keys with this software as codes are hidden behind the interface , You can also find the codes in the manual how ever one of the other chaps on the forum may be able to provide a link to...

Part and Inventory Search

Back
Top