Recent content by gooddy

Sorry how do i register the CPMG with the security domain

Im in the process of upgrading a pabx from rls. 4.5 to rls 7.0 I'm using the CPMG for IPMG 0 0 amd two MGC cards for 0 1 and 0 4. However none of the cards and the VGWC in the main cabinet comes up. I know the MGC has to be registered with the Primary Security Domain. Do I have to register the...

sorry yes i'm going from a cs1000e with an SSC

Its a CS 1000E

I'm upgrading a CS1000 Rls 4 to Rls 7. I can't get to migrate the customer data. I did an archive of the old system and copied it to the USB installation device. However the system does not see the archive as valid. I would really like to upgrade the database because I don't want to reprogram...

I am installing mobile x on a CS1000 6.0 system. It works well on incoming calls however I when I call the MSA number I don't get dial tone. When I dial the MSA number it activates the extension on my desk top but nothing happens. Can anyone help?

It is in the keycode folder but it is not the only keycode in there. I am using the software RMD with the 5.0 software so there are other files on there.

I'm trying to apply new keycodes on to a CS 1000E Rls5.0 and for some reason the keycodes will not load. Can anyone tell me what the procedure is the load the keycodes?

I am trying to configure mail boxes on the system however when I update the database nothing happens. The mail boxes don't get created. Can anyone help?????

I recenetly upgraded an option 11c to a CS 1000E Rls. 6.0 however the DSP are in a disable / unregistered state. How can i solve this problem?

I am trying to install a SCS 500 but i am not able to configure the system. I went through the initial installation but it never completed the process. I'm trying to use the "sipxecs-setup-system" command to redo the install but it does not work. Can anyone help Need to configure the IP address.

I recently upgraded an Option 61C to a CS 1000M and an Option 11C to a CS 1000E running software Rls 5.5 with VOIP trunks between the sites. I configured the GateKeeper and the NRS on the main site (CS 1000M). All CDP calls between the sites work fine suggesting the connections and...

I forgot the password for my callpilot mini. Does anyone know how I can get in or is there a higher level password I can use?

CPU 1 is in standby

When i try to swap from cpu 0 to cpu 1 i get a message which says "Health on local side is better than remote" and the switch does not happen. How can i fix this ?