Im in the process of upgrading a pabx from rls. 4.5 to rls 7.0 I'm using the CPMG for IPMG 0 0 amd two MGC cards for 0 1 and 0 4.
However none of the cards and the VGWC in the main cabinet comes up.
I know the MGC has to be registered with the Primary Security Domain. Do I have to register the...
I'm upgrading a CS1000 Rls 4 to Rls 7. I can't get to migrate the customer data. I did an archive of the old system and copied it to the USB installation device. However the system does not see the archive as valid. I would really like to upgrade the database because I don't want to reprogram...
I am installing mobile x on a CS1000 6.0 system. It works well on incoming calls however I when I call the MSA number I don't get dial tone. When I dial the MSA number it activates the extension on my desk top but nothing happens.
Can anyone help?
It is in the keycode folder but it is not the only keycode in there. I am using the software RMD with the 5.0 software so there are other files on there.
I'm trying to apply new keycodes on to a CS 1000E Rls5.0 and for some reason the keycodes will not load.
Can anyone tell me what the procedure is the load the keycodes?
I am trying to configure mail boxes on the system however when I update the database nothing happens. The mail boxes don't get created.
Can anyone help?????
I am trying to install a SCS 500 but i am not able to configure the system. I went through the initial installation but it never completed the process. I'm trying to use the "sipxecs-setup-system" command to redo the install but it does not work. Can anyone help
Need to configure the IP address.
I recently upgraded an Option 61C to a CS 1000M and an Option 11C to a CS 1000E running software Rls 5.5 with VOIP trunks between the sites. I configured the GateKeeper and the NRS on the main site (CS 1000M). All CDP calls between the sites work fine suggesting the connections and...
When i try to swap from cpu 0 to cpu 1 i get a message which says "Health on local side is better than remote" and the switch does not happen.
How can i fix this ?
Yes I can ping the gateway and the correct gateway is configured on the devices. The ELAN subnet is the same for all the devices connected on the network. There is a static route for the entire ELAN on thenetwork router. I can also ping other devices on the network which are connected to the...
I have recently installed a CS1000E with two MG 0 0 and 0 1 along with a Signaling Server. For some reason I am unable to access any of the above mentioned devices over the WAN. It works fine over the local LAN. Strange enough I can access the Call Server with no problems via the WAN. I have...
I have just upgraded an optional 11c to a CS1000 E Rls 5.5 and i am unable to datadump. Every time i run the command Edd i get an error EDD0039. ( Audit indicates Peripheral Controller and the superloop data do not agree. The datadump is aborted. Redefine the Peripheral Controller or superloop...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.