Recent content by ddmcp2000

OK, the installer "FIX" above didn't do it... any other suggestions from ANYBODY would be appreciated.

If it works with XPHome, it MUST work with XPPro. I think they mean "XPPro is not supported by Fujitsu" - not that the hardware won't support XPProp... This is SOP. MOST manufacturers won't support any OS other than the one that comes with the hardware. Try this: leave the floppy drive...

Not that it does you any good right now, but for future reference, and for any IT people out there looking for a way to monitor and track your PCs - Computrace, by Absloute software is a great way to do it. Link here: http://www.absolute.com/ I have used it and it helped me recover 7 stolen...

Please read the above linked page in the Citrix forum, and offer ANY help you might have! Thanks!

Still with the same issues, but now I have more information. The installer service boots up disabled. If I log-in in safe mode, I can enable the installer service, but upon reboot, it disables itself. All MS installer are now dead. DSRM does the same thing. I tried SFC, and it replaced SOME...

Another thing to consider? DRIVER SET STABILITY!!!! Here is where the ATI excels. I have had too many problems with nVidia driver sets not liking something about some anti-virus software or something else... ATI beats the nVidia handily here. There's my two cents!

My buddy swears by something called "Snap Stream" I think it's rediculous, but he says it's the best thing going on out there. Found at http://www.snapstream.com/ check into it. They have a blog and everything to ask questions BEFORE you buy it... One thing you must remember... the more...

Call Gateway, and see if there is something you are not seeing, or something we are not getting... If the monitor is fairly new, a support warranty should still be in effect. If you plug the analog cable into two different computers, and still get a black screen, then, if there really is...

This a "Not Hardware Dependent Issue". You seem to be in trouble... Was your old system Win2K? If so, read this: http://support.microsoft.com/kb/q175761/ The only way I can think of to fix this issue would be plug the drive into a system that uses the SAME operating system as the drive used...

Glad I could help...

There is probably a selection in the monitor's setup menu. My Neovo does the same thing, unless I turn off the device connected to the DVI - it's the primary input... If you plug in JUST the analog output from either computer to the LCD, without connecting the DVI cable at all, do you have the...

Here ya go... AND this will be a device you will be able to use again and again... Church events usually happen annually, right? Here's the answer for at least the next few years. http://www.compusa.com/products/product_info.asp?product_code=310146&pfp=BROWSE This whole thing, by the way...

bump, please...

As a second option, buy a PCI video card, not an AGP. Most MOBOS will allow a second ideo card, if it's PCI, but your MOBO only has *one* AGP bus... can't put two cards on one bus... it's like putting two feet in one shoe :)

It will depend completly on your MOBO. Some will allow a second video card (if PCI), but I have never seen a second AGP allowed. 1 bus, not 2...