SIP Trunk Configuration In SV9100

[a35]

Hello ,
for SIP Trunk in SV9100 configuration,
can someone provide me with the accurate method to config my system , i followed many manuals but there are some mistakes to take SIP Trunk , besides i did it many times with SV8100 .

for example need to connect SV9100 (192.168.0.10) with an open source (192.168.2.2).

 

[belevedere]

Who is the SIPT provider?

 

[Ali.Omari]

I don't have a provider , need to connect 2 systems via SIP trunk
NEC SV9100 with Grandstream UCM

the incoming calls from grandstream to SV9100 is OK, but cant go from SV9100 to grandstream

 

[belevedere]

Set up MB 10-23. Every leading number 0-9 + * + # to the IP address of the Grandstream.

 

[Ali.Omari]

unfortunately,
I did that before but still as it .
when i set the configuration at SV8100 it was OK , but SV9100 not .
I just need to know the differences between to solve this issue .

 

[belevedere]

The only differences are licensing. Are you properly licensed? Ports and SIP trunks?
This is for Charter SIPT's which set up in a similar way;
2.1.1 SIP Trunking Information from Charter Business
 Primary SIP Proxy Server IP Address.
 Number Plan, if applicable for the Point-to-Point Connection.
 Trunking DID(s)
The DID(s) are forwarded to the Public WAN IP address(s),
DNS or DNS SRV records of the PBX.
2.1.2 NEC UNIVERGE SV9100
 SV9100 CPU firmware Version 3.00.51 or higher
 GPZ-IPLE
 Digital, IP and TDM Telephones
 R1 Version License (0411)
 System Port License (0300)
 VoIP Resource License (5301)
 IP Trunk License (5001)
10-12-07 if using a NAPT router
10-54
10-29-03 - default proxy address
10-23, same as 10-29-03
10-36 ? not sure
10-67-01 - on
10-67-02 - DNS (8.8.8.8)
Do you have a line key assigned for one of the SIPt's? do you get dial tone when you access it? What do you get when attempting to dial out? Do you need CAR/CAP keys?

 

[miteshrathod85]

i connect to systems sv9100 with ucm 6108 via sip trunking ,,

are you connect in local ip or wan ip. and give me some detail plz

 

[Ali.Omari]

Hello ,
The connection between both systems is in my local network
and the routing rules are checked correctly
the calls from UCM6204 TO NEC is ok , but from NEC to Grandstream is not

if you please determine the notices you need to clarify any thing else

Thanks

 

[miteshrathod85]

grandstream inbound rules only confing dot or X in inbound rules and try incoming or you give me remote i check it

 

[a35]

Hi ,
can you please add your email to contact ?
my email is ali.omari@jaffalgroup.com

 

[miteshrathod85]

my mail is mit_rat8@yahoo.co.in

 

[Bibekshrestha]

Hi is the interconnection between Sv9100 and UCM6204 working??
Can you share the configurations on Sv9100 and UCM side.
email:bibek.multisys@gmail.com