Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

SIP Trunk Configuration In SV9100

Status
Not open for further replies.

a35

Systems Engineer
Sep 8, 2019
9
PS
Hello ,
for SIP Trunk in SV9100 configuration,
can someone provide me with the accurate method to config my system , i followed many manuals but there are some mistakes to take SIP Trunk , besides i did it many times with SV8100 .

for example need to connect SV9100 (192.168.0.10) with an open source (192.168.2.2).

 
I don't have a provider , need to connect 2 systems via SIP trunk
NEC SV9100 with Grandstream UCM

the incoming calls from grandstream to SV9100 is OK, but cant go from SV9100 to grandstream
 
Set up MB 10-23. Every leading number 0-9 + * + # to the IP address of the Grandstream.
 
unfortunately,
I did that before but still as it .
when i set the configuration at SV8100 it was OK , but SV9100 not .
I just need to know the differences between to solve this issue .
 
The only differences are licensing. Are you properly licensed? Ports and SIP trunks?
This is for Charter SIPT's which set up in a similar way;
2.1.1 SIP Trunking Information from Charter Business
 Primary SIP Proxy Server IP Address.
 Number Plan, if applicable for the Point-to-Point Connection.
 Trunking DID(s)
The DID(s) are forwarded to the Public WAN IP address(s),
DNS or DNS SRV records of the PBX.
2.1.2 NEC UNIVERGE SV9100
 SV9100 CPU firmware Version 3.00.51 or higher
 GPZ-IPLE
 Digital, IP and TDM Telephones
 R1 Version License (0411)
 System Port License (0300)
 VoIP Resource License (5301)
 IP Trunk License (5001)
10-12-07 if using a NAPT router
10-54
10-29-03 - default proxy address
10-23, same as 10-29-03
10-36 ? not sure
10-67-01 - on
10-67-02 - DNS (8.8.8.8)
Do you have a line key assigned for one of the SIPt's? do you get dial tone when you access it? What do you get when attempting to dial out? Do you need CAR/CAP keys?
 
i connect to systems sv9100 with ucm 6108 via sip trunking ,,

are you connect in local ip or wan ip. and give me some detail plz
 
Hello ,
The connection between both systems is in my local network
and the routing rules are checked correctly
the calls from UCM6204 TO NEC is ok , but from NEC to Grandstream is not

if you please determine the notices you need to clarify any thing else

Thanks
 
grandstream inbound rules only confing dot or X in inbound rules and try incoming or you give me remote i check it
 
Hi ,
can you please add your email to contact ?
my email is ali.omari@jaffalgroup.com
 
Hi is the interconnection between Sv9100 and UCM6204 working??
Can you share the configurations on Sv9100 and UCM side.
email:bibek.multisys@gmail.com
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top