Can anyone tell me the correct way to configure a carrier remote with 2 t1s with bandwidth available from both.I keep getting alarms from the non configured port. What does spared mean?...not used?...connected with t1 not used unless a other t1 goes down? I think they could have used a better choice of wording.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations John Tel on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Carrier Cofiguration
- Thread starter gutp1le
- Start date
acewarlock
Technical User
It's kind of hard to guess, can you post the alarms
This is a Signature and not part of the answer, it appears on every reply.
This is an Analogy so don't take it personally as some have.
Why change the engine if all you need is to change the spark plugs.
This is a Signature and not part of the answer, it appears on every reply.
This is an Analogy so don't take it personally as some have.
Why change the engine if all you need is to change the spark plugs.
spared means it's on the card and not used.. it is in the spare mode.. ie if you configure it in the software it will go to work.. you may need to get into the serial interface to look at the t for errors (slips/bipolar/etc) to make sure that it's config matches the build
john poole
bellsouth business
columbia,sc
john poole
bellsouth business
columbia,sc
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question