Two Carriers, CS1K Only Passes One to 2nd PBX

[ComradeSlice]

I have a CS1000 with three T1's: a DID PRI (NI2) from our local carrier, a TIE E&M from our long distance carrier, and a TIE PRI (QSIG/ISGF) that goes to an Asterisk PBX. I use DSC's to route extensions (4-digit) to the Asterisk TIE. Asterisk can make outgoing calls over the local and long distance trunks however incoming calls only go to Asterisk from the local trunk. Incoming calls from the long distance trunk to Asterisk get a fast busy. I see nothing on the Asterisk DCH when a call comes over the long distance trunk so I'm assuming the call is getting dropped because of the Meridian. Calls going from the long distance trunk to a Meridian extension complete successfully. What could be causing this? Here is some info.

Thanks in advance!

Local:

DES  LIGHTPATH
TN   006 01
TYPE DID
CDEN SD
CUST 0
TRK  PRI
PDCA 1
PCML MU
NCOS 0
RTMB 6 1
B-CHANNEL SIGNALING
NITE
STRI/STRO OWK OWK
AST  NO
IAPG 0
CLS  UNR DTN CND WTA LPR APN THFD HKD
     P10 VNL
TKID
DATE 27 JUN 2014

Long Distance:

DES
TN   009 01
TYPE TIE
CDEN SD
CUST 0
TRK  DTI
PDCA 1
PCML MU
NCOS 0
RTMB 4 1
TGAR 0
SIGL EAM
STRI/STRO WNK WNK
SUPN YES
AST  NO
IAPG 0
CLS  UNR DTN CND WTA LPR APN THFD HKD
     P10 VNL
TKID
DATE 15 JUL 2013

Asterisk:

DES  ASTERISK
TN   007 01
TYPE TIE
CDEN SD
CUST 0
TRK  PRI
PDCA 1
PCML MU
NCOS 0
RTMB 7 1
B-CHANNEL SIGNALING
TGAR 1
AST  NO
IAPG 0
CLS  UNR DTN CND WTA LPR APN THFD HKD
     P10 VNL
TKID
DATE 16 FEB 2018

 

[ComradeSlice]

DITI is PKG 131.

...
DTI2   129
TBAR   132
...

 

[KCFLHRC]

Didn't think the DITI prompt had anything to do with a certain software package, just thought it was a prompt in the Net_Data you turned off or on

DITI (NO) YES DID to TIE connections allowed

 

[ComradeSlice]

The phantom worked and changing FLEN to 0 on a DSC also worked. What exactly does FLEN do? My vendor said to set it to 4.

 

[KCFLHRC]

FLEN (0)-24 Flexible Length number of digits
Prompted with Flexible Numbering Plan (FNP)
package 160.

 

[KCFLHRC]

FLEN basically tells the PBX how many digits to look for before routing the call

 

[RickyPone]

So you're all set? I've seen FLEN work both ways. Sometimes you have to tell the far end how many digits you're sending and other times you can't tell it.

 

[ComradeSlice]

Yeah, everything's working fine. Thanks a lot!