500 v2 Cabinet Locked Software Version

[PBXMcGuyser]

I am trying to figure a way to see what version some used 500v2 cabinets are "Locked at". I understand that once one call is made from a 500v2 cabinet that Software version is written to the Motherboard and the Cabinet is locked to version and a license must be purchased to go beyond that version.

 

[Pepp77]

Either - run the upgrade wizard which will show you the licenced software release (ensure no upgrade licences are live on the config), alternatively if it is a default bit of kit, then just log into it and go to the licence tab and it shows the allowed maximum software release.

| ACSS SME |

 

[PBXMcGuyser]

Thank You Pepp77

 

[PBXMcGuyser]

The upgrade only shows what is available with a license upgrade to get to the version manager I am using. it does not show what the cabinet is currently locked at

 

[intrigrant]

This has been asked recently, use a serial cable and inspect the boot log with PuTTy, it will show the version it is locked on.

 

[PBXMcGuyser]

I have tried that, actually with Putty also. Did not see a SW version listed

 

[intrigrant]

Pre 6 systems don't lock on a version.