Search results for query: *

You can use your UDP table to send a number to the aar analysis table. The aar analysis table can then send to a route pattern. The route pattern will then have your ISDN trunk listed in the route pattern. In the route pattern you can also add or delete the digits needed for the far end switch.

One thing to make sure of is that the near-end listen port and the far-end listen port on your signaling group is set at 1719. Then on their side it needs to match exactly as you have it programmed. This can cause calls to not establish or one-way established calls. I typically use 1720 versus...

We run Avaya on all Cisco layer 2 networks. You have a voice vlan and data vlan it looks like. On our Cisco switch ports we set them up as access ports like this. (Example) int fa 1/0/1 switchport access vlan 1234 switchport mode access switchport voice vlan 4321 no mdix auto Is this what you...

You can also log into the the S8300 IP address via the web. Go to the maintenance page and in the left column select "Shutdown Server" We have approximately 40 Avaya LSP's and have had some people on the wrong systems do a "reset system 4" and take down the wrong system. By making people log...

You could ask the network person to verify that there is no access list in place blocking traffic. Is the CLAN plugged directly into the router or a layer 2 network switch? If a layer 2 network switch, see if you can ping the CLAN from the switch. If you can, then you know the network...

We do have some users that sit in external industry type calls for that long. I don't know how your billing is set up, but if I had a user dial a toll free number from my site for an external conference call, I would not see it on my bill as I would not be getting charged. (That's how are...

I don't know if it will help, but we saw this. We are using the TFTP MV_IPTel server from avaya. We placed the exact 46xx.setting.txt and all other files and firmware in the HTTPSdata, HTTPdta, and TFTPdata folders. This did help as any Avaya IP phone could use any method they wanted to grab...

The latest release is 071008 which will be version release 2.9 for the 4600 H.323 IP telephones.

You can also use li ars route 15081234567 (508 is the area code you are checking on and 1234567 just completes the number) It will let you know if it is in any ARS analysis table, call type, and route pattern the call is using.

Agreed that the first T1 span is interface ID 0. Also agreed that this type of configuration is reserved to T1 groups that connect to the PSTN via local provider. Typically with tie trunks you create a separate signal group for each T1 span and then add the new ports and sig group to the...

On the second page of the trunk form check and make sure the send name, send number, and send Called/Busy/Connected Number are set to yes. Also check the Format on the second page. If all of these are set to yes and the private numbering plan or the public-unknown numbering plan are not set up...