Search results for query: *

change the a-law/mu-law companding (ch sys cou ) and see if it resolves the issue.

thank you for your response Yes you are right, on the server side you have a single point of failure. thanks again

Hi We are about to install a critical reliability S8720/G650 CM4 ip-connect system. I want to know, if the two IPSIs in each PN (duplicated IPSIs) have to be in different subnets or if they can both use the customer LAN. Thanx

From Avaya doc "Feature Description and Implementation for Avaya Communication Manager" under Call Forwarding: "Call Forward Busy/Don't Answer cannot be activated for calls to hunt groups, data extensions, a TEG, or an Expert Agent Selection (EAS) agent.

Tke a look at this doc http://support.avaya.com/japple/css/japple?temp.documentID=282739&temp.productID=136527&temp.releaseID=282185&temp.bucketID=159898&PAGE=Document Under "Call Detail Recording"->"Call detail record field descriptions

Has anyone installed BCMR on a PC with a Dual Core processor? Is there any problem? BCMR doesn't support dual processors and i want to know if the same goes for Dual Core. Thanks jimtr

In CM 3, i think that "telnetenable" has changed to "ipsisession". Have that in mind and play around with the help pages jimtr

Sorry on number 4. the command is "telnetenable" NOT "telnettenable". jimtr

Hi If DHCP is used for assigning IP addresses to IPSI in a dedicated network, then after you dial in the S87xx: 1. "telnet 192.11.13.6" 2. "more /etc/hosts" to see the IP address of IPSI (i.e "198.152.254.1 ipsi-A01a") 3. "telnet 198.152.254.200" this is the ip address of the server on the...

is the 9620 working on firmware 1.2?? i have this fw on my 9620s and whenever i give <MUTE> CRAFT#, i get the craft menu where you have several options like "ADDR" for changing the ip addresses, "RESTART PHONE" , "RESET VALUES" etc.

Hi fw 1.0, 1.1: <MUTE> R E S E T # fw 1.2 <MUTE> C R A F T # and then navigate the menu to find "RESTART". jimtr

Hi I had problems with this also while trying to use Avaya's MV_IPTel I downloaded this free 500kB http server: http://www.rejetto.com/hfs/?f=dl And it worked fine!!! Hope this helps jimtr

Hi is there a cli command to reboot a s8700? thanx

Hi We want to move bcmsvu from one pc to another. Any general guidelines of the process? Thanks jimtr

TykeUK you are right you have to be on cm 3 and have "Vectoring(3.0 Enhanced)" assigned. sorry jimtr

TykeUK This is what you need, but i don't know if it available in your system 02 collect 4 digits after announcement xxx for none 03 set digits = digits CATL 7 04 route-to digits with coverage n 05 stop

Selleb, In the same screen you have an option to configure the "FTP Setup...".If no settings are configured there, you can not toggle the Automatic Backup option between "Disabled" and "Enabled". jimtr

dwalin, This is what i thought too. If we could change it, it would make our customer's reporting requirments feasible. Thanks for your answer. jimtr

Hi Does anybody know if it is possible to have the pbx change the UCID of a call when that call is transfered? thanks

mrjedi, what happens to the call?It drops or the vector processing continues to the next steps? I had this problem in the past with overlap/enbloc setting in the trunk where i inserted the vdn number in front of .The problem with this setting is that the pbx does not ignore whatever the...