Search results for query: *

I looked at this for a while. The answer is "it depends" (What I did) If you want eight or less DIDs sent to the fax server, you can get an two or four port ISDN card for the MICS. And an _active_ ISDN card your your PC (~$800). You get eight virtual fax lines (eight is the max the MICS...

I have a MICS 7.0 XC (upgraded from 6.1), PRI and an ASM with four fax machines. All work without problems both before and after the upgrade.

I have: a Norstar MICS 6.1 PRI card combo card BRI card a block of 20 DID numbers, 023-042 dial 8 to dial out ( not 9 ) 7 16 port station modules a call pilot 150 I do not use target lines for each person, only extensions (usually from CP150 AA) starting at 200 through 311...

hrwilliams99 stated: > Maybe it is that simple! That would be great! hrwilliams99 stated: >I am just in the process of ordering the second internet connection, so I will try that when I get to that point. Your original post didn't include the Internet in between the two cities. vastly...

I was going to order an Eicon Diva Server BRI any other recomendations on cards? and yes, it was easy to find a used one, as nobody had new ones :)

>> I got lucky because the PCI modem had a COM port on it. you need a serial port. In MSwin these are called com1, com2, etc. A PC internal modem includes both a com interface and a modem. you cannot connect the modem to the Cisco router, you need to connect with a serial port.

Thanks My vendor is looking for a test unit for me.

Hello... I have a MICS 6.1 with a T1/PRI, a combo card and a LS/DS (*) From some posts and docs I found on this forum (this is an excellent forum!) the BRI-U2/4 trunk card can be a network interface or a station side equipment interface. Does this mean I can output a BRI to connect to a...

>> I don't think that you want to try and split them out on the patch cords side?? Do you? nope :) Active Pins 4 and 5 , correct? Would these work? From Ortronics http://ortronics.smartcats.com (full URLs don't seem to work well) part numpers: OR-808004389 OR-808004041 OR-808004356...

Hello... I have a MICS with several MOX16 units. I'm adding another one soon. The others all have a cable with an amphenol connector for the MOX side and individual wires punched down into a 24 port patch panel. Is there any reason why I can't use a patch panel with a amphenol...

After some delays, I got it working, thanks to all > luv2ski (Vendor) Aug 23, 2004 > try there website "nortel" was free for awhile It took a bit of searching but it is still there > bkrike (MIS) Aug 23, 2004 > If you have a fastrad installed in your system, the > original vendor put it...

Thanks, followup: OK, FastRAD , got it check two ports, one serial DB9 and one RJ11, Which manual would the setup be described in? Or is there a seperate one just for it? ( The RJ11 goes somewhere, but the DB9 is empty) Norstar remote utils: Is this something that should have come...

Hello... Is there an easy way to backup (or view) the entire MICS configuration? I want to make some changes and it would be nice to have a config reference "Just In Case" :)