Since upgrade from TSW to TSE calling to DISA, dial tone *6*authcode# the call drops.
All ASPAC are verified to allow Parnum 184 = 2 Individual or common authorization code is
required on DISA calls.
We have upgraded 3 systems and the same result. We do have a ticket open with Mitel as of...
We have dest codes set up to send all toll free numbers over for DTMF.
We have one that we just can't get to receive our DTMF. Thank Goodness you can speak the prompts.
800 982 7144 TSE 4.1 dialing from BSA and BS soft client
Even tho we hear the choices it still shows 'dialing'. Thank you
MX-One Messaging 7.71 build 177, finally sent to site and installed.Patches 39390, 39463, 39600, 39966, IPLU DLL's changed and aculab as required.Beep IKA and IKU.wav added.A-LAW pompts,
IPGDP
LIM % FREE
1 98
DOMAIN: ONEBOX
CODECSLIST : B
MAXCALLS : 30
Call diverts to voice...
Thanks Daddy and CJ. It was a combination most likely of both your answers. I added to file .WD and RYSR2A.WD. I do notice when you send in lower case it does make it upper case. I changed it anyhow. Thank You again.
<CNBLI:PATH=/SYSN/USR1/SES/CN/FW/19112-rys10272,BPOS=9-1-60...
I've downloaded the new 11A firmware fine from directions below. Can someone help with 'how to' download the boot firmware? I followed the same procedure as to download the NIF11a for the NIU2. I see the file:
<fidap:PATH=/SYSN/USR1/SES/CN/FW/*.*;
FILE/DIRECTORY DATA
FILE...
Your print shows
<VMPOP;
VOICE MAIL PORT DATA
DIR PORT IFCIND
101 101 3
102 102 3
END
Is this a typo or have you tested with a group number set up?
VMPOI:GRP=XXX,IFCIND=3;
Hej LB
Working set up
cnvtyp=2
numtyp=2
and we
pre 9 1
for all incoming 2 through 9.
Numlog shows 9 1 then the incoming number.
When pressed it redials the number whether it be local or ld.
txpod LG
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.