Line protocol is {up | down} Indicates whether the software processes that handle the line protocol believe that the
interface is usable (that is, whether keepalives are successful).
Do you apply Frame Relay?
If the serial interface is up and the line
protocol is down, either the local loop...
I have ever such a problem:
After I turn off my router for more than half an hour and reboot, it will not work(even the power ok led turn to down). But it will auto load after 2 days or more with the power switch on. I doubt if there is a rechargable battery in the power unit and the unit will...
Hi,allanpoto
If you change the sentence
" ip route 200.0.0.0 255.255.255.128 FastEthernet0/1"
to
" ip route 0.0.0.0 0.0.0.0 FastEthernet0/1 250 "
I think it will work.
----------------------------------------
It is a waste of money to hire a leased line of 512k just...
You can:
copy run tftp:filename.cfg //keep your running-config
then, after you edit the filename.cfg
copy tftp:filename.cfg run //write back
...
Simon Yu
CCNP
Sorry, I don't understand what you print very much. But I think the floating route works fine,since "after 5 days the link stop".
What is in your route table when you disconnect the primary link ? Is the floating route appear? Do you apply NAT? Do you set any pessive-interface? Is...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.