Search results for query: *

Hi, I have come sccross this problem before and it turned out to be the power supply on each occasion (One of them was a new system in a new case.) Its worth a try before you start replacing expensive components. I Hope this helps - If Not - Sorry Regards from Mike

Different resolutions/colours often need the monitor alignment to be adjusted. If you have a digital monitor, ie; one that the screen alignment is controlled electronicaly - it will remember the settings for each mode so you will only have to set it once for each one. If it is the old analogue...

Hi, I'm not sure what is causing the problem but you can try forcing your system to boot normally by editing the MSDOS.SYS file. Make a copy of MSDDOS.SYS before messing with it. You will need to uncheck it's read-only attribute before editing. Open the file in Notepad Add a new line...

I had the same problems but Following jakespeare advice I found the answers at www.aumha.org/a/memmgmtz.htm and http://tweakhomepc.virtualave.net/memory/vcache98.html These sites have the answers and explanations. In short; I added the following lines to the [vcache] section of the system.ini...

My sincere thanks to Jakespeare (Vendor). His reply in another thread pointed me in the right direction and after various web searches I found the answers to these problems at www.aumha.org/a/memmgmtz.htm and http://tweakhomepc.virtualave.net/memory/vcache98.html These sites have the answers and...

I can't offer anything for the error you are experiencing but - The Black screen senario could be caused by the way your monitor is reading the new card. I have experienced the same problem with a Belinea monitor in windows 98SE. Try This - When the screen gets to the stage where the coloured...

Thanks paparazi, 98SE recognises the 1Ghz (100Mb) Ok. If I install a PCI graphics card everything works fine.

I have just built a new system using a P4-1.8Ghz cpu on an Abit BD7-Raid MoBo. If I use 2 x 512Mb DDR's, the system will only fire up in 640x480x16 on an AGP card. It will run all colours and resolutions with a PCI graphics card. If I remove either memory stick, leaving one, it runs with the AGP...