Search results for query: *

You can't lock it down to an IP address but you can lock it down to a mac address. Here is a link that will help you (use port security). http://www.cisco.com/univercd/cc/td/doc/product/lan/cat2950/1216ea2b/scg/swgports.htm#xtocid9 This feature will allow you to shutdown the port if a staiton...

This would not be a feature of the switch but a feature of the MSFC or MSM, depending on when you purchased the switch. You should be able to do it with NAT but if you are using MLS it will not work. The link below should help you get started on the right road. Once you look at the link and...

You will need the 100-Mbps ISL expansion module for the 3900 and then it should work with the 2924xl. You will need to run VTP version 2 to support the Token Ring. I have done this with a 5000 and a 3900 so the 2924 should work. You might want to contact Cisco just to verify.

You will need the 100-Mbps ISL expansion module for the 3900 and then it should work with the 2924xl. You will need to run VTP version 2 to support the Token Ring. I have done this with a 5000 and a 3900 so the 2924 should work. You might want to contact Cisco just to verify.

Plug your fiber cables in and then enter the following set commands on each switch: set trunk 1/1 on set trunk 1/2 on Once you do this one of the links will go into a blocking state and the other into a forwarding state; Of course this is the most basic setting. Since there is not much...

Try this link http://www.cisco.com/univercd/cc/td/doc/product/access/acs_mod/1700/1700cnts/ezvpn.htm

Im not sure if this is what you are looking for but have you tried multiple route map statments? What you could do is create multiple route map statment with the first statment matching your 10 network, after that you could use standard or extended access lists to filter individule networks to...

Try adding IP to your dialer-list at location A then ping the far end to see if it will intitiate the call (this will at least isolate the problem to the bridging). Also I noticed there are no SPIDS, do you not need these with your provider or does the basic-net3 switch not require SPIDS? Can...