To do this you will want to enter configuration mode and then enter the interface mode. Example:<br><br>router>enable<br>password:<br>router#conf t<br>router(config)#int s0<br>router(config-if)#<br><br>Then type the following with your info<br><br>ip address 10.10.10.10 255.0.0.0...
Bridging is considered old. Route the frame relay if you can. What kind of routers do you have at the locations and why do you want to bridge? <br><br>Jason <p> <br><a href=mailto:jcusick@visto.com>jcusick@visto.com</a><br><a href= > </a><br>
And in case you wanted to forward the IP address's to another network segment config the router with a helper address.<br><br>interface Ethernet0<br> ip address 10.x.x.x 255.0.0.0<br> ip helper-address 10.x.x.x<br> bandwidth 10000<br> ipx network xxxx<br> no ipx...
Purchasing a warranty for that specfic router is pretty cheap ranging from about 275 up to 440 bucks. Lower end will give you 24 hour phone support with next day parts all covered, and higher end up to 24 hour phone support with 4 hour response time for parts. This will be...
How do you want to set it up? Are you looking to forward address's from a specified DHCP server to another network or are you looking to actually configure a DHCP Server?<br><br>JasonC
Mark,<br><br> From what I have read that router is used for ISDN. Just curious with an environment of that size, I usually set up clients with DSL. You usually get the router from the company (675) for free. I would check to see if DSL is...
The best advise I can give you is to actually work on the physical router as much as possible.<br><br>I used a site to study <A HREF="http://www.masontech.com" TARGET="_new">www.masontech.com</A><br><br>The test was pretty hard, most confusing part and what I scored lowest on was the...
In response to my own question:<br>
<br>
The global address is not like a local address. The setup was as follows: My 2 remote sites I configured with the DLCI of my main location. I also set this up as a subinterface in the event that we would want to add an additional PVC later. The main...
Hello,<br>
<br>
I currently have three locations in my setup, A (remote location) C (Remote Location), and B (Main Location both PVC's from A and C term here). I was wondering what is the best way to set up this situation. Currently Location A can talk to B and C can talk to B but A...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.