Search results for query: *

make sure the prime is set to the set

be sure when you change to ring group 008 that the control set and lines are the same as the other 2. b

change DRT and trans call back to 6...b

cannot make a line A & R on voicemail, just assign a target line (with DID digits) to be ans by AA on 0...it works. b

overflow must be to a DN and the DN cf to voicemail to work. b

did you allow redirect on the vm ddn, or how many PRI lines do you have it takes 2 to transfer out...,and did you chose route in your external transfer and add 9??? bbb

sometimes the published IP address on theLan port is not the port you are dialed into...ck to see if you are dialing into Lan 2, and the publhsed IP addressed LAN 2 is chosen...bbb

each buss holds 32devices, and IP only uses 1 and 8 or 7 if a 3/5 split..if you IP devices are greater than digital devices, most likesly you need a 3/5 split..I did it and it allows more IP phones...but you must remove all users from bus 7..

When you upgrade to 3.0 you must download and install this or if you go to a level 2 reset it will go back to the previous software version...if you have already reset and back to 1.0 you will have to upgrade again, and, then install the Rel SG3.bbb

Have you had any modem problems with the 450

BCM 3.7 unable to access unified manager