Search results for query: *

To answer your question there is a way to do this. Its called Silent Monitoring you can monitor any extension in a hunt group. If you need more information just ask.

I run a VMware server its free setup when setting it up specify the OS as red hat linux 3 and partition type as ext 3 and give it 80 gigs of HD space seet allocate hard drive space to NO it will grow as needed. Of course theres more to it but this should get you started

When you are in UM and you click on Telephony Services you will see the path listed sometimes this gets changed to e:\ftproot so people can save FNVRAM to the FTP folder. Changed this to the path listed in the error message and that on the tool bar at top of screen click BACKUP (not sure if its...

Think of it like this are where a device/phone lives and the css is a list of partitions the phone can reach. Basically COS of service in traditional I.E Device A lives in partition internal phone and Device B lives in partition LD. If device A has the CSS Internal Phones and tries to...

I am new to this but is it possible that the region config of device pool has changed specifying a different codec for the phones withing in the device pool to use when calling phones in another region and the gateway is not configured to support the codec specified in region configuration.

There is known issue with the power connector to the module back plane that will also cause this symptom. There is bulletin posted about this. http://www116.nortel.com/pub/repository/CLARIFY/DOCUMENT/2007/15/021032-02.pdf

Good catch ADB100 didnt even notice that it was multicast address. Also Plshlpme you mentioned that routing protocols usually wont form adjacency with secondary IP's. Since you say usually what are the exceptions where they will? Also I thought that you always have to route between vlans I...

To route between two different networks on the same LAN interface you could use the secondary commmand as shown below. But you mention each let is in different VLAN's, so not sure why you say without using VLAN's it would seem as if you already have them setup. You wouldn't be able to use the...

We use NCM where I work we just started using it recently stilll learning but I would be interested in discussing what its capabilities are. Our deployment is 324 which is a mix of 3.5, 3.6, 3.7, and soon to be 4.0's. Haven't fully began taking advantage of it capabilities because we have been...