We have recently replaced an Audix LX 1.1 with Audix LX 2.0.
Yesterday channels 2 and 4 where answering and now today only 1 and 3. You can see the non answering channel been active in Channel monitor but it does not answer. Please could you possibly advise where we can look
Hey dwalin...
did you ever get info or test your labs connecting a Cisco ATA device to an Avaya., I saw in some posts that you had tried or where trying? I found some info in http://www.tek-tips.com/viewthread.cfm?qid=1208811. But looking for substantial answers
Thanks Terence
Hi
Has anyone managed to setup a SIP trunk to Exchange 2007 Unified Messaging with AVAYA CM3.1.2 (h.323)
I have the following:
Avaya s8300 CM 3.1.2 on a G700
Aavay SES 3.1.2 on a s8500 in simplex home/edge.
Any help would be greatly appriciated,
Thanks
Terence
yes the LSP in inservice/idle.
On the LSP it states in the logs:
illegal connection attempt from 10.11.1.132
Host 10.11.1.132 is not a valid source.
connection from 10.11.1.132 port 33678]
I have doubled checked my LSP information in configure server aand it is all good.
hi
I have an s8500B(CM 3.0.1)with a s8300 LSP(CM 3.0.1) in a G350. When I try save translatiosn to the LSP I get the following erros. Please Help:
s8500B:
20061101:000555843:432:filesyncd(6879):MED:[Performing filesync: set = pwd, type = LSP, targets = 2, bytes = 678]...
Hi Guys thanks for the information,
RFWatts, How do I check/enable that "Faststart" is enabled on AVAYA.
whatsanavaya, Can you send me your network region 4?
thansk
AvayaEng
Hi
I have a s8300 in a G700 running Avaya CM 3.0.1 and need to setup up H.323 Trunk to an Asterisk 2.3 PABX using openH323 1.1.2 running on CentosLinux. The link runs between a PIX firewall. With the ip address of the Asterisk and the s8300 able to see each other. The IP of the MGP VOIP engine...
Hi
I have a s8300 in a G700 running Avaya CM 3.0.1 and need to setup up H.323 Trunk to an Asterisk 2.3 PABX using openH323 1.1.2 running on CentosLinux. The link runs between a PIX firewall. With the ip address of the Asterisk and the s8300 able to see each other. The IP of the MGP VOIP engine...
thanks, Okay what I have done is routed all my calls that where going to the PSTN via the G700 to an S8500 and braking out there. there is no QOd issues.
I'm not sure where to find the synchronization on a s8300 with G700.I have set up a second DS1 card in the G700 and made a call using a Trend...
Hi
Have an IP phone 4601 on an G250 registered to an G700+S8300. When I call another IP phone in a different location the QOS is fine. When I brake out to the PSTN via the G700. I get very bad GOS. all my IP-Codec-sets arre G729A. the VoIP on the G700 is using G729...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.