Search results for query: *

Sorry for the delay in responding, guys appreciate your help, the port and IP address were configured, the problem was caused by my running an older version of Manager , I upgraded that the problem was solved. thanks again

I have an SOE with 4.2 the manager cannot access the system over the wan, although it can be pinged. (it will connect over the LAN.)

Problem identified as being the firmware load on the sets, the serial numbers are in the range of the defective ones manufactured late last year. The vendor and I are having a serious conversation. Implemented the temp fix but this probably didn't sole the problem as software level is to...

Thanks,appreciate it, how do you go about loading that earlier version on those sets?

I have an IPO 403 with no expansion modules and five 5410's that work fine. Recently added 2 new 5410's. Neither set will register; they simply display a message that states 'please wait' Any Idea's? I could buy 1 bad set, 2 seems unusual

Thanks to all you guys. The routers are Cisco, ICMPMAN you put me back where I needed to be, and you are correct that I do not have access to the IPO to connect to the DTE port and my local people would not be much help. Although that is a good idea as well. Thanks a bunch

You might be confusing a PRI and a older digital trunk type. Your local service is a PRI where the caller id is sent over a D-channel (typically channel 24) Typically direct connect T1 from a LD service are DS0 channels of 56k each, control signaling (line seizures, inbound and outbound...

Have a couple of IPO's (4.0) that the IP addresses have been lost,(connection is over a WAN) I remember reading ina document that it is possible to recover the IP address's through a monitor process on the site's routers but am unable to locate the documents again. Does anyone have that bit of...

Having trouble with an IPO 500/voicemail PRO turning off the MWI. System is R 4.00 with 64xx sets

Thanks Intriguant, it went well

have never done an upgrade, would like some advice

Having Similiar issue with 4.0 However System status reflects the correct time while monitor is an hour ahead. Time on phones and time of day routing is off as well. Any ideas?

I would setup one t1 as a clock source and set the other to take timing from the network (provided by the other end) You can't have two timing sources, for one thing they will never sync