Search results for query: *

Also keep in mnd your 2600 needs to have a fa to do vlan / trucking routing

GZ .. correct me if I;m wrong but you can not do router on a stick with all 2600 routers... only the ones that have 10/100 ether...

This is very correct...know the commands... I did the into exan and had 3 sims... 2 sims it work 1 it did not...

What is STP for? 1.) Prevent Routing loop 2.) Maintenance a loop free enviroment on Layer 2. 2 is the correct anwser.. Split Horizon is used to prevent routing loops

If ou dont have a new OS... try deleting the start up config if you havent already..

Agreed there isnt enough collision to be concerned with... however he moved e0 to full duplex. Why would he see collision in full dup... Thanks

you may have a problem with the media or there is an encapsulation mismatch.

its the 80211 authenication mode ... normally found in advanced... you have open share auto... try each of these to rule this out...

in the acu ... you have the opion for open and shared key.... switch it from the one it;s on now to the other... if not set correctly you will have connection issues...

A few things you want to do... 1) You stated your using a Cisco PCMCIA card. - D/L the Cisco ACU (Aironet Client Utility) for your card. This is Cisco's program for monitoring the card and config of the card. Once loaded you will get a signal Icon on the bottom bar. 2) Are you able to get...

I would also consider getting a switch too... 1900 are cheap on ebay ...

I'm new to CISCO routing .... so take this with a grain of salt... If your host are not on the same network as your gateway (router / firewall) you're not going to be able to access the internet.

Can either one of these routers be hooked up to a cable modem for home use? The 2501 has the AUI which I have hooked up to the network adapter. The 2507 has a internal hub... thanks