Search results for query: *

Hi All I am new to Cisco firewalls and require some help setting up Cisco VPN Split Tunnels. I've pasted my Config with this message. I think the config sgould enable me to provide Spilt Tunnel VPN but it does not work. Does anyone have any ideas why?? Best Regards Bhavesh PIX...

here is a simple guide I use when recovering + a bunch of technet websites * Note the partition sizes of the runnign machine * Install O/S with same service pack revision as original machine * Create identical partitions to original machine * run performance optimizer on original machine and...

I'm pretty sure when you restore an exchange 5.5 server, from backup tape... the patition sizes, the server name and Exchange organisation should be exactly the same when trying to recover

when you use Exmerge all mails get downloaded onto a pst

Maybe try Exmerge... it should be part of the exchange resource kit

Hi I need some serious assistance. I bought this switch of ebay to help me prepare for my CCNA exam. It was working fine for a few days then suddenly It went dead. The dump below shows that the ports are not responding to the loop back test and switch is just hanging. Is their anyway I can...

Thanks for your advice Regards Bhavesh

Hi Guys I'm very new to Cisco PIX firewalls and need some advice. I would like to change the IP address of my Inside Interface from example 10.100.1.253 to 10.100.1.248. What would I have to do change the interface IP and would their be any dependacies within the PIX for the Inside IP address...

Do you have a copy of your dsdata folder from the backup your trying to restore... the Dir.edb would have to match when installing the priv.edb our pub.edb. Either use technet to trouble shoot errors, or rename the current dsdata folder and recover the old one from the backup... Good luck B

Usually depends on what backup software / method you are using. Usually theirs only two types Mailbox backups or Brick level (Priv & Pub.edb). I user Veritas 8.5 backup software and do a full backup of the IS and DS every night, So If I wanted to recover a mailbox I would have to recreate a...

I seem to have an incosistant database after restoring the IS and DS using veritas, does someone know how to make the database consistent...??? so I can start exchange again

Hi Guys I need help with an exchange recovery. The server is now off line and used to be our old PDC with Exchange 5.5. We have moved to a new Exchange 5.5 server, which works great. My problem is that I'm trying to do a brick level recovery on my old server by recovering IS and DS...

Solved it, Mailsweeper seemed to be cause of the problem. It did not like the IP address of the exchange server Thanks Bhavesh

Hi Guys I can send and recieve across my exchange site. I can recieve external mail but I cannot send any emails out. Every time I try I get a msg in outlook saying Your message did not reach some or all of the intended recipients. Subject: Sent: 15/04/2003 13:32 The following...

Hi Basically I have three exchange boxes in one site, I wanted to remove one of the boxes. This box used to hold our emails and IMS and Notes Connector. I have moved over everyone’s mailboxes to a new server and wish to move these two connectors also. I was wondering if could create two new...

My exchange server seems to work really well across all sites, only problem is that it seems to refuse a connection from an exchange server which I cannot find, constantly producing the following two error msg Event ID 9301 The message transfer gateway that uses the network address C73301DE...