Search results for query: *

I have tried this with a Z-blocker filter but enough high freq data "noise" gets though to trigger Harris' data lockout on the Butt Set. Do you have a model of filter that you know works? I have put several Z-blockers together to get the TS22 to go off-hook but it cannot be placed back into...

I have a TS22AL that I have used for years for POTS testing. With more and more DSL on the lines, the need is there for a cheap filter/splitter which will allow POTS testing. I have put a few Z-Blockers in series to get by the Harris Data Lockout feature but it unbalances the line so much that...

See faq: faq798-4335

If it is always the same TNs then the Digital card is probable going bad. Consider replacing it.

I have seen PollCAT use effectively. It is also good for offsite phone billing. http://www.lucenttelephonesystems.com/Info/PollCAT.htm

Try faq798-4335

Do you have an phantom TNs? If so you can configure it as follows for forwarding to VM or an outside number. This is immediate call fowarding with no delay. You can also do this to a normal 500 type TN with no phone attached. DES CELLFD TN 156 0 01 1 PHANTOM TYPE 500 CDEN 4D CUST 0 DN...

Did this fix your problem? If not you may be using NAR/BARS for Class of Service controll. If this is the case you will have to change the NCOS setting to allow the phone to forward to outside the local network.

That works perfectly. :0) Thanks a lot, JKSim

I, like many people, use a terminal emulator to access my Meridian Mail system. The problem is that the F5 key is not setup correctly to use the last soft option presented in the Meridian Mail menus. Anyone out there know the string of bytes that is sent out by the actual dummy terminal for...

ggggggggrrrrrrrrrrrrrrrrr As it turns out, I did it right to begin with. My service provider was sending the DID on the wrong PRI. So all is well. Thanks for all your help, JKSim

Also I was told that I have to refresh or do something that tells the switch that the tree has been changed. It is true and how do I do this? Thanks for your time, JKSim

The IDC is connected to the correct route, I believe. How can I print the route configuration including the IDC associations?

I have an incoming DID number that I have ported that begins with a 9. 9 is my systems BARS access code. Therefor the incoming DN needs to be converted so it can be used internally. I added the IDGT to an existing IDC tree. This did not work. Do I need to attach the IDC tree to the incoming...