Hi
I have a CS1K Rel 7.6 and can't login with admin on it. It gives me an invalid password message. The admin2 and root are working.
Can anyone tell me how I can recover that password?
Thank You
@intrigrant
I'm just answering the post and the questions- It is not easier to go to the costumer and implent the sugestions. I'm In West Africa, Not seating in an office with remote access to the PBX. I really don't need your comments. If you Think the posts are too many, just don't watch them...
The 9 can not be striped. It is needed. The all number would be 943 XXX XXX
And for Land Lines would be 2XX XXX XXX
9 and 2 are not codes, They are part of the number
I don't have a System short Code for that now, but I had it before and did not work either
Short code: 9XXXXXXXX
Telephone Number: .
Feature: Dial
Line Group ID: 0
Here is the Sysmonitor. Is not using the 9XXXXXXXX, but another shortcode that does exactly the same 2XXXXXXXX
10:26:33 947416474mS SIP Rx: UDP 192.168.42.11:5060 -> 192.168.42.1:5060
INVITE sip:222222222@192.168.42.1:5060 SIP/2.0
Via: SIP/2.0/UDP...
In some other models of PBXs, CS1K for example, there is a way to prevent trunks from one trunk to get out trough another trunk. Is there any kind of restriction on the IPO?
The two PBXs are on the same building, just connected with a Cat6 cable (switch to Switch).
I'm sending the 9. the outside numbers are 9 digits starting with 9. That is why the short code is 9XXXXXXXX
this short code is working on the IPO phones.
I have a IP Office Rel. 10.1 (PBX1) in one location connected to a MyPBX (PBX2) in another location.
The outside lines are on PBX1. The Extensions on PBX1 one are 3XX and on PBX2 are 4XX. The internal calls work with no problem between the two PBXs. On PBX1 I added a Short code, 4XX to...
Hi
I have a CS1K,Rel 7.6, with a PRI/E1 NTBK50, that needs to be reseted every morning to work. The LEDs on the board face plate are all green, the LD 60 > Stat looks good, but the calls don't go trough until I reset the PRI. This has been since the software was re-installed.
Can any one help...
ld 43
RES xxx The file created to store the MIB-II variables, System
Navigation variables, and community name strings is
restored from the backup (external storage) device to
the primary device.
basic-19
Where xxx = removable storage device type.
• RMD = Compact Flash device
• USB = USB memory...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.