Hi,
We are using a tape backup unit with travan tapes in an intel based Win2k server. I have configured the backup and it runs fine on "run now". However if put on say a weekly schedule it reports and error message saying media not found.
Thx in advance
Hi,
I have an exchange server connected directly to the internet with a static ip. Sending mail is working like a breeze. Recently I have had to close an open relay on this server and ver since no one is receiving email. The DNS is setup for two outside serversand is resolving ok I think.
Any...
Hi,
I am constantly getting an "Inaccessible boot device error" blue screen error. Previously there was an error related to the video driver. Its loading the installation so I beleive it has found the boot folder. Any ideas would be much appreciated.
I have a backed up copy of a hard drive with outlook 2000 with all emails and settings. I have installed Outlook 2000 on the new PC. Where does outlook store its data ? PST backup was not done and now cannot be done.
Any suggestions would be much appreciated.
Are u using any software for Internet routing ?
I've seen that over a certain period of time few sites especially SSL, SOCKS related sites get disabled on the routing software. Possibly a memory leak on the server causing some sort of overflow.
To get around it I created a new service using...
Seems like a hardware is causing Setup to fail.
Check Setuplog.txt for any helpful information. You might get helpful info on the offending hardware.
Secondly, try installing the server with the least amount of hardware possible attached to the system. Then add 1 hardware at a time and see when...
Was the first install a fresh one ? If so did you do a complete format of c: ?
I have win2k Server, Pro and Xp Triple booting no problems. If this is a test machine I would reccommend a fresh format and fdisk. Otherwise try repairing the first installation and choose to repair the boot...
The only way I can think of is through the DHCP server...You could bind DHCP issued IP address to the MAC addresses (NIC) on the office machines. Then only those machines have that IP address. You will need to restrict server access to only the DHCP Scope defined. You will probably need to set...
Insert the tape that you want to restore from and catalog it. U didnt mention what Backup software u'r using so I'm assuming its Win2k Server Backup program.
It seems to me that your Ethernet Interface is not configured properly. Check the IP Configuration on the interface. D you have a backup of the router config to refer to. See for any differences in the same.
I had a nightmare configuring RRAS and NAT and finally got it working but was unstable at times. I am now using PPPShar pro from www.pppshar.com. It is simply the most amazing and simple to use software for ADSL connection sharing. Just have your external and internal interfaces on and run the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.