Search results for query: *

This is the only one I've done, so no I haven't seen that happen.

Thanks for your reply. User error again!

Ran into this the other day. While upgrading an IP 500v2 from 6.0 r8 to 6.0 r18 with the manger 8.0 R18 and entering the password in the upgrade page as I read the sheets it was telling me to enter the system password. Doing this would end up with a "fail to load" message. After many attempts...

I need to know how to connect to a VMP with Putty and and change the time. Thanks for any help.

Help! I'm trying to change the time on a VMP installed in a 192. trying to do via DTMF and can't find the option for it in the Managers programing. I've gone to scheduling and the system tells the time but move on to the option of changing schedule A. Thanks for ant help.

MercuryComm I gave that a try and found no option to change the time. This system as a VMP card. does that make a differents?

Thank you! Is this something that as to be done everytime there is a time change or is there a setting to do it automaticly?

Is there a way to change the time in the the VM on a 192 via DTMF Thanks for any help

Thanks to both of you. If I could I like to pick your brains with a VM question. Is there any way to change the time on the newer VM installed in a 192 without using cosessions?

I have a customer with a Elite 48 that has 1 ETW 16d phone set. I think the set is going bad but when I plug in a DTU set it will not work on that port. I've looked but don't see anything in programming were you would set a port for one type of phone or the other. HELP!

I'm on site and need a copy of CosSession utility. Can anyone help? Thanks

Need some help on on connecting a T-1 to a Pro II using a on board card. The customer bought the system used including the card. I can get the T up and stable but can not complete a call. Mapped a button for the T but just get an error tone when dialing. The provider is not passing dial tone and...

Thanks for the info folks. I'll get it a try today and let you know.

I believe its a fast busy w/ the display blank.

Yes, card 1 is prime ans 2 is 2nd. Both are set to decening. I have thought about an upgrade and already have the software. Just worried about loosing all the programing, are there any knowns problems with the upgrade?

I just added a 2nd PRI to a MICS 5.0 Each morning the customer has a alarm 42. I've had a vendor meet and have run loop back test, no problems found. Had the CO take them down while I was on site a couple of times and everything came back OK. Powered down system and everything came back up, no...

What type of incoming lines do you have?

Yes the tray is aways empty when this happens.

Thanks for the advice folks. I'll give it a shot and let you know.

Got a problem here. Every so ofen the cd writer ( my E drive) will start to open and close repeatedly by itself. At the same time the cd writing icon appears next to the mouse curser. I have to reboot to spot it. Any help?