Search results for query: *

Hello! I was just wonder where the purge clutch is because I have a similar problem. I have a Phaser 850, and this thing prints one page perfectly, but the second is jammed right when it is about to come out. About half way. Then it goes inside about 1/3 of the way and stops saying there is a...

Hello! I have a Tektronix Phaser 840 that gives me the folowing error code 08,001.1.44:95210. Could someone please give me some help on this Thanks Shafqat Shah

Hi i have a phaser 850 that gives me the fault 07,004.46:22916 when at start-up. what's the fix??? Thanks Shafqat Shah

Hello! The preheater thermistor appers to be poen. Replace the paper preheater. Thnaks Shafqat Shah

Hello! Your drum heater is not heating at all. cheak the connection or open thermistor in power supply

Hello! The error code 15,004.45.2593 with phaser 380. It means the drum heater is not heating at all, or is not heating quickly as it should. Check for open connection or open thermistor in power supply. this error may occur if the printer side panels and top cover are removed when sercving...

hello! Sanding it made a little difference, not much Thnaks Shafqat Shah

Hello! For the 340 phaser with the error 06,001,42. it means x-axis home position not found. Indicates that the x-axis home sensor has failed, or something has prevented the printhead motion during a home operation Thanks Shafqat Shah

Hello! For the phaser 850 with the erorr 07,002.44 it means the process motor stalled during operation. this has several possible causes, depending on what the process motor was gear-connected to at the time of failure. Thanks Shafqat Shah

the link for the manual is http://www.hannurisys.co.kr/tek/pdf/pdf/mu/360.pdf thanks Shafqat shah

Hello I was working on the 850dp and had the same problem what I did was I took the printer apart and there is a small cluch thing that drives the top exit rollers. I took that out(remove the clamp). Take a sand paper and make the surface rough of the little rod that the thing was one. make...

Hi! THere is also a configuration on the computer check that is the Printer Folders Shafqat Shah

Hello Did you find anything on the paper jamming. I have the same problem. Shafqat Shah

Hi I need that cable that you have, where did no get it form Shafqat Shah

Hi! There might be some small paper stuck in the duplexer. Check the paper-path. if it is new send it back to Hp. For Checking the paper path: Take a paper and put it in were the paper enters and push it until it comes out. Also check the paper size that you set. Shafqat Shah

thank you very much!!! shafqar shah

hey! you might try looking for a lose sensor or something else messed up thanks shafqat shah

hi! I have a phaser 350 that give me a error 04,005.44:10161. do u have any ideas. please help me thanks Shafqat Shah

yes! phaser 350 is fixed we repalced solenoid switch thanks for tip. Thanks! shafqat shah

Thank you very much. It helped. Thanks, Shafqat Shah