Search results for query: *

can you show us an example of this DCH mon

if you have TIE connection you have to specify CTYP in DMI what is used in RLB

did you try to enable DCH MON on PRI connection between A and B in LD96 to see if it is a CLID information in setup msg. from switch A?

if you use the TTY port from SDI or QSDI ,you will have a permanent connection to active CP the same is with IP ,just connect with RLOGIN to active ELAN

have you the T1 connection to Meridian?

Hi, does any one successfully config and run the Time sync from M1 to Miran Card? I set a M1 IP in T&D Sync menu, Enabled is set to true, but i see no changes after the time period. Please any help will acceptable. Thanks.

LD 22 REG SLT and TID

LD 117 => INV ? INV PRT - Print STATUS, CARDS, SETS or ALL INV GENERATE - Generate inventory CARDS, SETS, ALL or ABORT INV MIDNIGHT - Generate inventory CARDS, SETS, ALL, OFF or STATUS

pls. try to find with search option in this forum more about this. But in principle you have to remove LD30 from OVLY in ld 17.

did you set in LD 15 FTR_DATA in OPT HVA?

And what about incoming calls to modem? I get max. speed 33.6Kbps. Any ideas?

do you have a package #351

Yes my file contain the CDR data. This is from o11. Directory of 'c:/u/smp_db': SIZE DATE TIME NAME ---------- ----------- -------- ------------ 3 Oct-28-2003 13:33:00 DBA.INI 38776 Oct-29-2003 11:25:02 DBA.CDR...

I try to enable in Data Buffering & Access window with start a new session for my M1 CDR collection. (I have LAN connection to the M1) After that (if the first CDR come)was a current.cdr file created on HDD in Norte/Common Data/"site name"/"system name"/DBA.

Do you have access to PDT?

Do you enable also the BDI in LD 15 CDR_DATA?

For DMC i receive Modem Adaptor AO773252PT But it also go with Modem Eliminator A0601397 DMC and DB9 connector(female) cable DMC - DB9 T1 - 7,8 R2 - 4 T3 - 2 R3 - 3 T4 - 7 Amphenol pin number T1/R1 26/1 White/Blue Blue/White T2/R2 27/2 White/Orange Orange/White T3/R3 28/3...

For Firmware Upload you have to be on site, with serial connection to the DMC4 Card. You can use the Modem Eliminator(for M1)+Serial Cable to make a connection to the DMC4. If the standard procedure for upload after this is not working you can try the following steps: -perform Backup on DMC4...

and how are you connected?

are connected locally with serial cable?