Search results for query: *

This is an italian application system using ESPA protocol, can you provide any information based on ESPA?

Can anyone supply PASAI and TLU 80 1/4 connector programming and wiring to the Ascom 942PX module?

Where are you located? Are you using an NIU?

We are setting up a VSU to play a welcome and queue message on an incoming trunk call via an E1 to a Common Operator. We have set up the CORGS, CALT and RA commands but it will not play. Internal calls to the OC work fine, ASPAC 116 set up for internal and external calls. Any ideas why...

Finally figured it out and that was the problem - thanks for the reply!

I need to add a new DID number to an NBX 100 with r604 SW and a PRI. What are the steps? I know this is done in the Dial Plan but I am not exactly sure about editing the file and importing it back into the system? Will it cause the system to reboot?

We have holiday greetings set up for Memorial Day, 4th of July etc. in our AA - TD Greetings. The problem is when I select a greeting - for example memorial day and I tell it to play on Time of Day and Date Range for a certain exisiting AA it will not play - What am I doing wrong?

I am trying to connect a remote LIM via CAT5 with a GJUG4 ROF1314247/4 and the L board is a GJUL4 ROF1314246/7 R3A. Does anyone know if this will work and if so what are the TX-RX pins on the boards?

Having a strange issue with a 3COM NBX 100. We have 2 sites, The main site is connected via a point to point T1 to the remote site with 3Com Routers and an uplink card in the remote cabinet. Whenever we make any programing changes no matter how small we loose the remote site cabinet and phones...

Thanks, Does the G board use the same pin locations as the L board, I cant seem to find the G pins in ALEX?

Has anyone tried to connect a LIM back to a GSM using CAT5e shielded cable on the 120 ohm ports? In this case the distance is less than 150 feet.

Can anyone suggest the ROCAI, RODAI and RODDI for a TLU76/1 to an Astersik box? The MD will be user side and the E1 will be a tie line. Thanks

It is a BC9 system

can anyone verify the procedure for "follow me and group hunt follow me? I thought it was *72*xxxx from an extension where xxxx is the follow me point amd *72* xxxx*yyyy# for a group xxxx is the group you want to forward and yyyy is the ansering group?

What is the best way to default it?

Having trouble setting up a new CP150, changed the IP from defualt via serial to 192.168.1.50, laptop to 192.168.1.1 subnet 255.255.255.0 on both Launched IE - http://192.168.1.50 to connect to CP manager to initialize but I cannot connect? IE Says it opening the page and then times out. Any...

Cannot initialize new CP 150. Verified IP address to be default 192.168.110.10, changed laptop to be 192.168.110.11 subnets on both 255.255.255.0. I can ping the CP but cannot connect via Internet Explorer to initialize. Tries to clear browser cache etc. But cannot connect, any ideas?

Forget last submission - found in previous thread on an I series phone top row button 6 from the left is F. button 1 being the top left button

One more question - would the "F" key be the same as the HELP key?

Thanks, I think it makes sense now.