Search results for query: *

All the Nortel Switches should send out BTDP packets. This will advertise the IP addres of the unit. You can use sniffer to pick these up. It is on multicast address. That is profided that it has not been switched off. Hope this helps

Good day I am having the same problem in Optivity 10.2 - can not get a faultscript to run. Any suggestions. Regards

Hi Use 2 of the Cisco DB 9's withe the roll-over cable. Set the term as 9600,8,no par. Press enter a number of times. Regards

Hi If you press the reset button, wait 5 sec and press it again. Then you should get a monitor menu. You can retry the upgrade from here. Regards

Hi I would suggest that you upgrade to V 2.69. If you still do not have joy check out the distance and the diameter of the fiber to see if it conforms to the speck. Regards

They should not go down. You can have 2 IP addresses. Check the code version on the 2 to make sure that they are running the same version. Try 2.69. Regards

Which passport is this? 8600 - if so what is the code version. Have you changed any of the timers on VRRP?

What version of code are you running on the 8600?

There is a reset button at the back of the switch. Press it and the press it again within 15 sec, you should have your console connected. This will bring up a menu that should help you. Hope this helps.