Search results for query: *

Hi We have problem about polycom trio 8800 connect ip office every well ,but when using ipoffice authcode , the trio 8800 will only show calling screen , and cannot show soft keypad that key in authization . Now the polycom is using firmware 5.9 and ip office is rel 10.1.2. How can I made...

When no S8300 inserted , just bustout all ds1 and station board on that gateway and then power down and move out. When have S8300 inserted , you must shutdown and backup the S8300 server first .

console port is use rs-232 port to connect service port is use ip to connect

Do you have another alarm when display alarm ?

HI mnealtx when pull out the power unit , use eletric torch toward see the cabinet inside pin is good or bent.

Before replace power unit,also check the scc cabinet backplane pin is good.

I have a case all analog card suddleny dead with power unit. We doesn't know why ?

do you have spare tn2793b or tn 746b analog card ? You can replace one card for test good or problem

have you check the cabinet backplane pin is good ? Because when plug in this power it may make the pin bend ? This power is old model no hz setting.

DC power or AC Power , if AC power you should turn to 20Hz on America or 25Hz in Euro. when using DC power , it is no selectable switch.

most of case is Power unit problem . Howerver does the message lamp flash when ringing ?

Thank you The setting is add to public/private number table , I have try when the agent id trun to extension number , the voice mail can answer the call. thanks

Hi we aare using cm 5.0 and call center we meet the problem agent Id assign coverage path to IA770 when 3 rings later the IA770 didn't answer the call. IA 770 is normal when office station use. Anyone know what wrong ? Thanks

it is use for config d-channel of ISDN-PRI

I Think you must check the q-sig mwi config first

Please try using Alaw when config E1

Are you using analog port for receipt call . if yes it may some parameter on port detect voice .

HI as i known aar and ars is same feature , but ars always us in external call , ars always use in internal network call (e.g. uniform dialling).

or you can use v2 chassis power circuit replace your 500v1 power , that is the same.

As I remember , only can use hold button or use Headset replace your handset.