Search results for query: *

That has been EoL for 5 years now. Avaya sold it's data business to Extreme last year. As a result there is nothing on the Avaya site and nothing on Extreme. There is no way to get software for it.

Mixed stacks are supported. Have you tried making the ERS 3549 the base unit? The release notes say that a mixed stack needs at least 5.1 software, but the 3549 was released with 5.2 software. What software are you running on the stack? I would make sure it is 5.2 or higher. As well as...

VSP 4450 don't support stacking. You can just daisy chain them together. If you purchase an advanced licence you can cluster them with SMLT.

The cost is the how the router decides which route to use. The route with the lowest cost is used. set the cost of your static route to 2

Add IP address to Vlan config vlan <vid> ip create <ip_address/mask> To enable IP routing config ip forwarding To create a static route config ip static-route create <ip_address/mask> next-hop <ip_address> cost <value> show vlan info ip show ip forwarding show ip route info

You can only view the log file through a telnet/console session. You could do a session capture through putty. If you want to capture the logs as they happen you will have to setup a syslog server and then the switch will send any log entries to the server as they happen.

default username and password: admin/setup If these don't work you will need to use a recovery disk to default the switch. If the administrative password is lost, the Nortel VPN Router can be set back to factory defaults using the method described. All of the following requires that the...

From your descrition it sounds like the switch is routing for all vlans. How does your switch route to the router, Is it static or dynamic routing?

Some power commands show poe-main-status show poe-port-status <port-list> show poe-power-measurement <port-list>

Check that the following are true 1. PoE is enabled globally 2. The port AES is enabled 3. The PoE priority for the port is configured to Low If still having issue can you post the switch config?

What switches and software level are you using?

diag 5.1.0.7 looks to be in the 5.4 software train. If you can get a copy of 5.4 software image from Avaya or your support company, you can load the image from the diagnostic menu. You can only upgrade the agent image from the diag menu, not the diag software. The only other option is to...

Try replacing the cable between port 2 and the router. If that doesn't work try moving the connection from port 2 to another port. If that doesn't work try moving the port on the router.

Your router with 92.87.95.49 address needs to NAT the public IP to a private address. You need something like below. Private addresses cannot be on the public internet because internet routers will not route private addresses. Router (NAT) Public: 92.87.95.49 (to ISP router) Private...

Can you post The vlan, ip, and dhcp config and a "show ip dhcp-server pool

when you create the mlt there will be a short disruption as the mlt forms, but it should only be seconds. For stp just disable it on the mlt ports. this will create 2 different stp domains 1 in each location. so any re-convergence will not leak to the other building

you could try a Ethernet Routing Switch RPS 15

topologyChange messages come from the stp root switch to signify a change in the topology. As can be seen by the following "Trap: newRoot". If no ports are going up/down on the 5510 try looking at your other switches in the network to see why the topology is changing..

also try checking auto-neg settings.

Multiple Sw exceptions are usually bugs. Do you have DHCP fwding/snooping enabled? You could try disabling the feature to see if it solves the problem (proving it's a bug). The hex is referencing a memory location not an IP address.