Search results for query: *

The TA series from Adtran is a good box also. ACSS- CM and CMM Have you tried to turn it off and turn it on again?

Look at the AudioCodes MP-114 or the like with FXO ports to emulate the CO. ACSS- CM and CMM Have you tried to turn it off and turn it on again?

Check your port duplex settings, thats where I would start. Found the info below in the Maintenance Alarms guide. Post your software version and a little more about your set-up. For the Sys-Link error EAL Expansion Archangel Link terminating at an Expansion Interface board. This link carries...

If you do make a change and get kicked out or lose control of the box, just have someone on site reboot it. As long as changes haven't been saved you will be ok. It's not the nicest solution, but it will work as long as you can communicate with someone exactly what to reboot.

I am curious too. There is the cmgHardware 1.3.6.1.4.1.6889.2.9.1.1.10 OID that has mentions of temperature, but when running against both a g430 and a g450 using the Solarwinds Network Engineers Toolset I get nothing other than Unsupportred OID. I'm going to keep playing around and will let you...

Not sure what you mean about the vendor not letting you have the info, support.avaya.com and search for "Documentation Library 5.2.1, or 6.0, or whatever version you need.

But is the format of the number being sent correct. Again, not knowing how your carrier will accept the call, but is the format of the number being sent to the loop able to be dialed the same way if you hook a test set up to the loop?

Glad you got it all figured out. You're right, sometimes you just have to step back and get another set of eyes on it.

DOH!

Type of phones? Type of trunks? Carrier?

An MST trace may be the only thing left to do right now. "Change MST", set ISDN-PRI to y all others no, set your filters on page 2. Then "enable mst" make the call, "disable mst", go to the SMI and grab the log under System Logs -> Communication Manager's Message Trace Analyzer (MTA). Post the...

If you are dialing the tac directly, do not dial 9. Not sure how your carrier accepts dialing for your area, but try dialing it as a 7 digit number or 1+ if needed.

list trace tac and post the results.

Plug a 2500 or butt set into the line and see if you can place a call

Do you have the correct loop type configured for the trunk group? Can you dial the TAC directly?

Even if you think they are wrong, the telco will never admit it! Source: former telco employee :)

Check your incoming call handling treatments for that trunk group. "display inc-call-handling-trmt trunk-group 60" If nothing is in there do a "list trace tac xx" where xx is the tac of your trunk group. Is the main number you are calling in on a toll free number by any chance? Maybe 7928 is the...

Take a look at page 3 of "display station 7928" and see if call forwarding is enabled. Also take a look at page 2 of "status station 7928

No problem. Go to support.avaya.com. Search for "Documentation Library xx", where xx is the version of software you are running.

You almost typed out the the command! From GEDI type status media-gateways. Use the F5 key for help completing commands.