SYS-Link Error Code

[thecmancan]

I'm seeing

SYS-LINK EAL ERROR 1793 NO AUX DATA errors hit the switch.

Also, I see an ADJ-IP 3671 NO AUX DATA error hit.

Are these anything to worry about?

I looked up the sys-link error it's about slow transmit due to traffic. Is that sign of potential hardware failure?

The ADJ-IP 3671 error was not even in the PDF I had with the alarm codes.

Any help is appreciated.

 

[crash29]

Check your port duplex settings, thats where I would start. Found the info below in the Maintenance Alarms guide. Post your software version and a little more about your set-up.

For the Sys-Link error
EAL Expansion Archangel Link terminating at an Expansion Interface board. This
link carries CCMS messages.
Error Type 1793: This error indicates that the link has experienced slow transmit rate due to
unknown causes, meaning that the endpoint location may experience slower throughput
rate and the Packet Interface may experience backup or congestion. The system link is
alarmed if 4 or more errors of this type are detected within 10 minutes.
1. Follow the information in Common Procedure for Repairing Link Problems.
2. Clear errors and wait for 10 minutes.

ADJ-IP 3671
There is an inconsistency in switch data records.

 

[thecmancan]

It's at CM 5.2.1 SP8, this customer hadn't upgraded since forever.

I was just nervous if these errors are point to some serious issues with the hardware.